Parts list for humidifier – GeneralAire 800 Legacy Manuel d'utilisation

Page 2

Advertising
background image

FORM NO. 800-II Rev. C (FILE 10238)

Litho in U.S .A.

Connect 1/4" water supply tube to humidifier. Copper tubing
requires a brass compression nut and brass sleeve. Plastic
tubing requires a brass insert inside the tubing, a plastic
sleeve on the outside with a brass compression nut.

DO NOT USE PLASTIC TUBING IN CONTACT WITH
ANY HOT PLENUM SURFACE OR DUCT. IF USING
PLASTIC TUBING, USE TUBE SUPPORT
PROVIDED.

PARTS LIST FOR HUMIDIFIER

SADDLE VALVE INSTALLATION INSTRUCTIONS

Copper Pipe
1. Retract piercing pin into valve body by turning handle
counterclockwise.
2. Screw valve body into upper bracket and tighten.
3. Place rubber gasket over piercing pin.
4. Assemble saddle valve over copper pipe using enclosed screws,
nuts and lower bracket.
5. Tighten screws evenly and firmly. Brackets should be parallel.
6. Complete compression connection to saddle valve outlet.
7. Turn handle clockwise to pierce tubing and close saddle valve.
8. Turn handle counterclockwise to open saddle valve, leave open for
several seconds to flush dirt from pipe and tubing.

Steel, Brass or Hard Plastic Pipe
1. Shut off water supply and drain pipe.
2. Turn handle clockwise to expose piercing pin and close saddle valve.
3. Place rubber gasket over piercing pin.
4. Drill 1/8" hole in pipe using a hand crank drill to avoid shock hazard.
5. Assemble saddle valve over steel, brass or hard plastic pipe using
enclosed screws, nuts and lower bracket.
6. Tighten screws evenly and firmly. Brackets should be parallel.
7. Complete compression connection to saddle valve outlet.
8. Turn handle counterclockwise to open saddle valve, leave open for
several seconds to flush dirt from pipe and tubing.

Threaded Pipe Fittings
1. Turn handle clockwise to expose piercing pin and close saddle valve.
2. Seal valve body threads using pipe tape or sealant.
3. Install valve into 1/8" NPT fitting.
4. Complete compression connection to saddle valve outlet.
5. Turn handle counterclockwise to open saddle valve, leave open for
several seconds to flush dirt from pipe and tubing.

Turn on water supply and check operation of humidifier. Check
flow of water by removing inspection plate and observe drip
tube. Humidifier will gradually fill 3/4 inch to 1 inch deep and
shut off. To accelerate filling, move valve actuator plate
toward pan through inspection opening.
NOTE: THIS HUMIDIFIER HAS BEEN FACTORY ADJUSTED
TO OPERATE ON WATER PRESSURES FROM 20 TO 150
P.S.I. NO ADJUSTMENT SHOULD BE NECESSARY.

5

6

FACE PLATE

800-M

VALVE BODY REPAIR KIT

896

SCREEN DISC

800-N

VALVE DIAPHRAGM

800-DM

INSPECTION PLATE

800-E

ADJUSTING SCREW

800-L

ACTUATOR PLATE & PAN

DIAPHRAGM ASSEMBLY

800-GMF

DRIP TUBE
800-K

EVAPORATOR PAN

800-IJ

EVAPORATOR

PLATES

(Set of 5)

880

NOTE: 800-IJ phenolic evaporator pan with
cast in plate rack and pan baffle is
interchangeable with 800-I pan.

Advertising