Draw-Tite 59721 ROOF RACK - Manuel (Page 3)

No PIÈCE
Capacité de charge
Installation des joints de caoutchouc et des multi-coussinets
Page 1 de 2
50 kgs - 110 lbs
59720-1N Rel. 10/26/11
Fig 2b
A. Remplacez un capuchon de point d'ancrage, de l'ÉTAPE 2, par un des joints de caoutchouc fournis.
Assurez-vous que le joint de caoutchouc est correctement orienté.
Chaque joint de caoutchouc comporte une flèche d'orientation.
Assurez-vous que le trou central du joint s'aligne sur le filetage du point d'ancrage dans le toit.
B. Placez le multi-coussinet de plastique sur le joint de caoutchouc.
Assurez-vous que le multi-coussinet est correctement orienté.
Assurez-vous que le trou central du multi-coussinet s'aligne sur
le filetage du point d'ancrage dans le toit.
Répétez les ÉTAPES A et B pour les adaptateurs restants.
Lorsqu'elle est placée correctement sur le véhicule, la flèche qui se trouve sur la surface supérieure du joint en
caoutchouc pointe vers l'avant du véhicule.
59720 -59721
Fig 1
Anchor Point Cover
Remove existing clip bracket. Keep bolts
to fasten ROLA Adapter Bracket.
Remove Anchor Point Cover. Fasten ROLA Adapter Bracket
with same bolts.
A B C
Fig 2a
Step 1: Removing the Anchor Point Covers and replacing Automotive Manufacture’s Clip Bracket
To remove or re-attach the End Support Cover. Insert the narrow end of the
End Support cover into the top of the End Support (Fig. 2a & 2b).
Twist the End Support Cover clockwise to lock it in place.
Fitting Instructions
APX Style Roof Rack
with Ditch Adapter Bracket
Prior to Assembly, check that your Roof Rack Box contains all the parts as shown above. Ensure that the vehicle roof is clean and dry.
Please note that some illustrations depicted in these instructions are only representative and your items may look different. Read these
instructions carefully before commencing. You can use a protective cloth when installing your racks to protect of vehicle’s finish.
On the vehicle roof you will find 4 Anchor Point Covers. Carefully remove these covers by sliding in the direction shown on the cover, to reveal the clip
bracket (Fig 1-A). Using a 10mm socket wrench, replace existing clip bracket with the ROLA Adapter Bracket reusing the bolts that secured the clip
bracket, as shown (Fig 1-B & C).
NOTE: Take care when removing Trim Covers to avoid damaging Trim Cover Clips. Covers can not be replaced while rack is mounted. Covers can be
replaced over the ROLA supplied Adapter Bracket. Store the Anchor Point Covers and existing brackets safely while the Roof Racks are in use.
Imprimé en Chine
Note: Keys may be
packaged separately
Plastic Adapter
Rubber Gasket
End Support
Support Cover
T-Handle
Security Key
M6 Mounting
Bolt
Screw
Lock Key ROLA Adapter Bracket
Tool Needed
Cross Bars
Parts List
10mm socket and wrench