Draw-Tite 59707 ROOF RACK - Manuel

Prior to Assembly, check that your Roof Rack Box contains all the parts
as shown above. Ensure that the vehicle roof is clean and dry.
Please note that some illustrations depicted in these instructions are
only representative and your items may look different.
Read these instructions carefully before commencing.
You can use a protective cloth when installing your racks to protect
of vehicle’s finish.
Hyundai Accent 5 Door
2012 and Up
Roof Rack Installation Guide
PART No.
Carrying Capacity
Step 1: Removing the Anchor Point Covers
Installing Plastic Adapters and Rubber Gasket Pads
Page 1 of 2
K
IT
C
O
MP
O
NE
NT
S
Fig 1
Fig 2a
50 kgs
100 lbs
Note: Keys may be
packaged separately
59707
59707N Rel. 7/27/11
Item Description Qty.
1 End Support 4
2 End Support Cover 4
3 Plastic Adapter 4
4 Rubber Gasket 4
5 Grey T-Handle Tool 1
6 M6 x 50mm Bolt 4
7 #6 Self-Tapping Screw x 3/8 4
8 Lock & Key set 4
Plastic Adapter
Rubber Gasket End Support
Support Cover
T-Handle
Security Key
Bolt
Screw
Lock Key
Anchor Point Cover Anchor Point
On the vehicle roof you will find 4 Anchor Point Covers. Carefully remove
these covers by sliding in the direction shown on the cover, to reveal the
anchor points (Fig 1). It is advisable to screw the Special Bolts into the
Anchor Points at this time to clean the threads.
NOTE: Take care when removing Trim Covers to avoid damaging Trim Cover
Clips. Covers can not be replaced while rack is fitted.
Store the Anchor Point Covers safely while the Roof Racks are in use.
To remove or re-attach the End Support Cover. Insert the narrow end of
the End Support cover into the top of the End Support (Fig. 2a & 2b).
Twist the End Support Cover clockwise to lock it in place.
Fig 2b
Vehicle’s Roof
Step A:
Install Rubber Gaskets & Plastic Adapters on vehicle roof. Align the holes in
adapters & gaskets with threaded insert anchor points.
Ensure the Rubber Gasket is oriented correctly.
Each Rubber Gasket is marked with a directional arrow.
Ensure that the center hole in the gasket lines up with the
anchor point thread in the roof.
Step B:
Locate the Plastic Adapter onto the Rubber Gasket
Repeat STEPS A and B with the remaining Adaptors.
Ensure the Plastic Adapter is oriented correctly.
Ensure that the center hole in the Plastic Adapter lines up with the
anchor point thread in the roof.
When positioned correctly on the vehicle, the arrow shown on the top
surface of the Rubber Gasket points toward the front of the vehicle.