Draw-Tite 20267 WIRING ADAPTER - Manuel

Installation Instr uctions
Directives de Montage
Instrucciones de Instalación
Electric Trailer Brake Control
Wiring Adapter
Adaptateur pour câblage
de commande de frein de
remorque électrique
Adaptador del cableado de
control eléctrico del remolque
18267-037 Rev. A 12/01/04
READ THIS FIRST:
Read and f ollow all instructions carefully
before beginning installation.
LISEZ CECI EN PREMIER:
Lire et suivre toutes les instr
uctions
attenrivement avant le montage.
LEA ESTO PRIMERO:
Lea y siga todas las instr ucciones cuidadosa-
mente antes de iniciar la instalación.
d f
e
ENGLISH
1. Locate the v ehicle’s electric brake
control harness. This harness is
located behind the storage pocket
just above the vehicle’s ashtray
towards the center of the dashboard
d. Carefully remove the storage pock-
et and locate the 4-pin grey harness
connector plugged into the rear of
the pocket that matches the end of
the brake control adapter
e.
2. Disconnect the har ness from the
storage pocket f. Plug the brake
control adapter into the vehicle’s
electric brake control harness
connector. Use butt connectors and
attach the wires from the adapter to
the corresponding wires on the electric
brake control, following brake control
manufacturer’s installation instructions.
NO TE: V ehicles not equipped with
OEM trailer tow package, may require
fuses and relays to complete output &
battery feed circuits (sold separately).
Consult owners manual for locations.
W ARNING
Complete the installation per the
electric brake control manufacturer’s
instructions and mount the unit as
directed. Perform test procedures
as instructed.
W ARNING
Ov erloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. 4 axles: 8 brakes (24 amps)
Read vehicle's owners manual
and instruction sheet for
additional information.
FUSED TRAILER BRAKE CONTROLLLER
BATTERY FEED
ALIMENTATION À FUSIBLE DE LA BATTERIE AU
CONTRÔLE DE FREINS
CONDUCTOR (CON FUSIBLE) DE LA BATERIA AL
CONTROLADOR DEL FRENO DEL REMOLQUE
VEHICLE STOP LAMP SWITCH TO
BRAKE CONTROLLER (INPUT)
COMMUTATEUR DE FEUX D'ARRÊT DU
VÉHICULE AU CONTROLE DE FREINS
INTERRUPTOR DE LUCES DE FRENADO DEL
VEHICULO AL CONTROLADO DE FRENO (ENTRADA)
TRAILER BRAKE CONTROLLER (OUTPUT)
CONTRÔLE DE FREIN DE REMORQUE (SORTIE)
CONDUCTOR DEL CONTROLADOR DE FRENO
(SALIDA) AL FRENO ELÉCTRICO DEL REMOLQUE
GROUND
MISE À LA TERRE
TIERRA