Draw-Tite 59721 ROOF RACK - Manuel

Prior to Assembly, check that your Roof Rack Box contains all the parts as shown above. Ensure that the vehicle roof is clean and dry.
Please note that some illustrations depicted in these instructions are only representative and your items may look different. Read these
instructions carefully before commencing. You can use a protective cloth when installing your racks to protect of vehicle’s finish.
Fitting Instructions
APX Style Roof Rack
with Ditch Adapter Bracket
PART No.
Carrying Capacity
Step 1: Removing the Anchor Point Covers and replacing Automotive Manufacture’s Clip Bracket
Installing Plastic Adapters and Rubber Gasket Pads
Page 1 of 2
Fig 1
Fig 2a
50 kgs
110 lbs
Note: Keys may be
packaged separately
59720 - 59721
59720-1N Rel. 10/26/11
Plastic Adapter
Rubber Gasket
End Support
Support Cover
T-Handle
Security Key
M6 Mounting
Bolt
Screw
Lock Key
Anchor Point Cover
Remove existing clip bracket. Keep bolts
to fasten ROLA Adapter Bracket.
On the vehicle roof you will find 4 Anchor Point Covers. Carefully remove these covers by sliding in the direction shown on the cover, to reveal the clip
bracket (Fig 1-A). Using a 10mm socket wrench, replace existing clip bracket with the ROLA Adapter Bracket reusing the bolts that secured the clip
bracket, as shown (Fig 1-B & C).
NOTE: Take care when removing Trim Covers to avoid damaging Trim Cover Clips. Covers can not be replaced while rack is mounted. Covers can be
replaced over the ROLA supplied Adapter Bracket. Store the Anchor Point Covers and existing brackets safely while the Roof Racks are in use.
To remove or re-attach the End Support Cover. Insert the narrow end of the
End Support cover into the top of the End Support (Fig. 2a & 2b).
Twist the End Support Cover clockwise to install in End Support.
Fig 2b
Vehicle’s Roof
Step A:
Install Rubber Gaskets & Plastic Adapters on vehicle roof. Align the holes in adapters & gaskets with
threaded insert anchor points.
Ensure the Rubber Gasket is oriented correctly. Each Rubber Gasket is marked with a directional arrow.
Ensure that the center hole in the gasket lines up with the anchor point thread in the roof.
Step B:
Locate the Plastic Adapter onto the Rubber Gasket.
Repeat STEPS A and B with the remaining Adaptors.
Ensure the Plastic Adapter is oriented correctly.
Ensure that the center hole in the Plastic Adapter lines up with the anchor point thread in the roof.
When positioned correctly on the vehicle, the arrow shown on the top surface of the Rubber Gasket
points toward the front of the vehicle.
ROLA Adapter Bracket
Remove Anchor Point Cover. Fasten ROLA Adapter Bracket
with same bolts.
A B C
Printed in China
Parts List
Tool Needed
Cross Bars
10mm socket and wrench