Installing the optional network board – Panasonic WJ-HD500A Manuel d'utilisation

Page 14

Advertising
background image

14

Installing the Optional Network Board

The Network Board WJ-HDB502 is installed exclusively in
the WJ-HD500A Disk Recorder.

1. Unplug the power cord from the WJ-HD500A Digital

Disk Recorder, or disconnect the plug from the AC out-
let.

2. Remove the top cover of the Disk Recorder by remov-

ing the 11 screws, as shown in the figure.

3. Remove the small plate covering the 10/100BASE-T

port hole on the rear of the Disk Recorder by removing
the screw shown in the figure.

4. Remove the 6 screws on the board, as shown below,

disconnect the CN403, then turn over the Main Board
with the front side up.

Disk Recorder
WJ-HD500A

10/100BASE-T

CN403

Main Board

5. Connect one end of the supplied flat cable to the

brown-colored receptacle on the main board, as shown
in the figure.

6. Place the main board and CN403 as before, and

secure them by tightening the reinstalled screws.

7. Remove a screw on the bracket as shown in the figure,

and then fix a supplied grounding wire by tightening the
removed screw.

8. Place the Network Board on the brackets, as shown in

the figure, then secure it with the grounding wire by
tightening the 4 supplied screws.

9. Fix the 10/100BASE-T port to the rear panel with the

screw removed in step 3.

10. Connect the supplied DC power cable and the other

end of the flat cable to the board, as shown in the fig-
ure.

11. After installing the board, secure the top cover by tight-

ening the screws.

Main Board

Flat Cable
(Supplied)

Flat Cable
(Supplied)

DC Power Cable
(Supplied)

Tighten

10/100BASE-T

Network Board

Rear Panel

Grounding Wire

Advertising