Pioneer PDP-504CMX-S - Manuel (Page 39)

33
En
Other Operations
English
Other Operations
About audio output (AUDIO OUT)
The signal level produced at the AUDIO (OUTPUT) jack
can be set to [FIXED] or [VARIABLE] (linked to the
VOLUME) as desired.
1 Press the MENU button to display the menu
screen.
MENU INPUT1
ENTER SET EXIT MENU
PICTURE SCREEN SETUP OPTION
: 0
: 0
: 0
: 0
: 0
: 0
CONTRAST : 0
BRIGHTNESS
R.LEVEL
G.LEVEL
B.LEVEL
H.ENHANCE
V.ENHANCE
PICTURE RESET
2 Use the 2/3 buttons to select [OPTION].
MENU INPUT1
:
: ENERGY SAVE
SCREEN MGT.
:
OFF
: ORBITER OFF
: MASK CONTROL ON
: AUTO SET UP MODE INACTIVE
: AUTO FUNCTION OFF
: AUDIO OUT FIXED
STANDARD
LANGUAGE ENGLISH
ENTER SET EXIT MENU
PICTURE SCREEN SETUP OPTION
3 Use the 5/∞ buttons to select [AUDIO OUT].
SET MENU
MENU INPUT1
:
: ENERGY SAVE
SCREEN MGT.
:
OFF
: ORBITER OFF
: MASK CONTROL ON
: AUTO SET UP MODE INACTIVE
: AUTO FUNCTION OFF
: AUDIO OUT FIXED
STANDARD
LANGUAGE ENGLISH
CHANGE EXIT
PICTURE SCREEN SETUP OPTION
4 Press the SET button to select the desired audio
level setting.
The factory default setting is [FIXED].
Each time the SET button is pressed, the function
alternates as shown:
÷ FIXED ............ Audio output volume remains fixed,
even if the VOLUME controls are
operated.
÷ VARIABLE ..... Audio output volume changes in
response to operation of VOLUME
controls.
5 When finished with the setting, press the MENU
button to return to the normal screen image.
Note
The [AUDIO OUT] setting affects all input sources.
3 FIXED
VARIABLE 2
3 OFF
INPUT1 2
4 Press the SET button to select [INPUT1].
The factory default setting is [OFF]. Each time the
SET button is pressed, the selector function switches
alternately as shown:
÷ OFF .......... [AUTO FUNCTION] is disabled.
÷ INPUT1 ..... ÷ When a signal is detected at INPUT1,
the input source automatically
switches to [INPUT1].
÷ After the [AUTO FUNCTION] mode
has caused the input to switch, if the
input signal is no longer detected, the
input source reverts to the one
selected before operation of the
[AUTO FUNCTION] mode.
÷ If the input changes when the unit is
in [AUTO FUNCTION] mode, pressing
the INPUT button to select a different
input will cause the [AUTO
FUNCTION] mode to be temporarily
disabled, but it can be enabled again
by turning the power ON/OFF.
5 When finished with the setting, press the MENU
button to return to the normal screen image.
Notes
÷ The [AUTO FUNCTION] for [INPUT1] is supported only when a
separate SYNC or composite SYNC analog RGB signal is input.
(When a G ON SYNC or component video signal is input,
[AUTO FUNCTION] is disabled.)
÷ The [AUTO FUNCTION] setting affects all input sources.
MENU
2/3
5/∞
SET
MENU
5/∞
SET
2/3
Main unit operating
panel Remote control unit