Pioneer PDP-504CMX-S - Manuel (Page 37)

31
En
Other Operations
English
Energy saving settings
(ENERGY SAVE)
The power control function allows screen brightness to
be suppressed as a means of lowering power
consumption and reducing display deterioration.
1 Press the MENU button to display the menu
screen.
MENU INPUT1
PICTURE SCREEN SETUP OPTION
: 0
: 0
: 0
: 0
: 0
: 0
CONTRAST : 0
BRIGHTNESS
R.LEVEL
G.LEVEL
B.LEVEL
H.ENHANCE
V.ENHANCE
PICTURE RESET
2
Use the 2/3 buttons to select [OPTION].
MENU INPUT1
:
: ENERGY SAVE
SCREEN MGT.
:
OFF
: ORBITER OFF
: MASK CONTROL ON
: AUTO SET UP MODE INACTIVE
: AUTO FUNCTION OFF
: AUDIO OUT FIXED
STANDARD
LANGUAGE ENGLISH
PICTURE SCREEN SETUP OPTION
Other Operations
MENU
2/3
5/∞
SET
MENU
5/∞
SET
2/3
Main unit operating
panel Remote control unit
Under factory default settings, the screen display
contents will change as follows:
* The color and brightness of the current image are displayed in
inverse values. The respective RGB color output levels are
inverted, with light areas appearing dark, and dark areas
appearing light.
Notes
÷ When set to [ONCE], after the screen management program
ends, this part of the display will change to the [OFF]
message. If you wish to continue the screen management
program, use the
2/3 buttons to select [ONCE] again, or
change to [REPEAT].
÷ During screen management operation when set to [ONCE] or
[REPEAT], if the display’s MAIN POWER switch is turned OFF,
the screen management program will end, and this part of the
display will change to display the message [OFF]. If you wish
to continue the screen management program, use the
2/3
buttons to select [ONCE] or [REPEAT] again.
6 Use the 5/∞ buttons to select [TIME TO
ACTIVATE].
SET MENU
:
:
RETURN EXIT
SCREEN MGT.
REPEAT STATUS
01H00M TIME TO ACTIVATE
START
7 Use the 2/3 buttons to set the time you wish the
screen management program to begin.
When the
2/3 buttons are pressed, the screen
management operation can be set from 0 to 24 hours,
in 10-minute units.
8 Use the 5/∞ buttons to select [START].
SET MENU
:
:
SET EXIT
SCREEN MGT.
REPEAT STATUS
00H10M TIME TO ACTIVATE
START
Note
The [SCREEN MGT.] setting affects all input sources.
Set
[ONCE]
Set
[REPEAT]
Inverse
image* White mask
display
Power standby mode
Screen management
function ends here
Inverse
image* White mask
display Power
standby
mode Inverse
image*
This cycle repeats
10 minutes 30 minutes
10 minutes 30 minutes 10 minutes
24 hours
[TIME TO
ACTIVATE]
(set in step 7)
[TIME TO
ACTIVATE]
(set in step 7)
9 Press the SET button.
The set value will be stored in memory, and the
screen will return to that shown in step 2.
The timer begins when the SET button is pressed,
and after passage of the time set in step 7, the screen
management program will begin operating.
10 When finished with the setting, press the MENU
button to return to the normal screen image.