Pioneer PDP-504CMX-S - Manuel (Page 24)

18
En
System Settings
English
System Settings
[CLAMP POSITION] setup
Depending on the signal, analog RGB signals may result
in the screen image appearing with a whitish or greenish
cast. In such cases, set [CLAMP POSITION] to [LOCKED].
Normally, leave this setting at [AUTO].
3
Use the 5/∞ buttons to select [CLAMP POSITION].
SET MENU
V G A
:
: SIGNAL FORMAT
CLAMP POSITION
:
AUTO
POWER MANAGEMENT OFF
MENU INPUT1
CHANGE EXIT
PICTURE SCREEN SETUP OPTION
4 Press the SET button to select [LOCKED].
The factory default setting is [AUTO].
Mode selection will change as follows each time the
SET button is pressed:
5 When the setup is completed, press the MENU
button to exit the menu screen.
Notes
÷ The [CLAMP POSITION] setting is supported only for INPUT1.
÷ When making this setting, be sure to confirm the signal output
of the component used. For details, consult the component’s
Operating Instructions.
3 AUTO
LOCKED 2
1 Press the MENU button to display the menu
screen.
MENU INPUT1
ENTER SET EXIT MENU
PICTURE SCREEN SETUP OPTION
: 0
: 0
: 0
: 0
: 0
: 0
CONTRAST : 0
BRIGHTNESS
R.LEVEL
G.LEVEL
B.LEVEL
H.ENHANCE
V.ENHANCE
PICTURE RESET
2 Use the 2/3 buttons to select [SETUP].
: V G A
:
:
SIGNAL FORMAT
CLAMP POSITION
:
AUTO
POWER MANAGEMENT OFF
SET MENU
MENU INPUT1
CHANGE EXIT
PICTURE SCREEN SETUP OPTION
MENU
2/3
5/∞
SET
MENU
5/∞
SET
2/3
Main unit operating
panel Remote control unit