Pioneer X-MT2000 - Manuel (Page 29)

29
7 Additional Information
English
En
Cleaning external surfaces
To clean this unit, wipe with a soft, dry cloth. For stubborn dirt, wet a soft cloth with a
mild detergent solution made by diluting one part detergent to 5 or 6 parts water, wring
well, then wipe off the dirt. Use a dry cloth to wipe the surface dry. Do not use volatile
liquids such as benzene and thinner which may damage the surfaces.
Moving the unit
Before moving the unit, remove all discs loaded. Moving it with discs loaded can damage
the unit.
If transporting the unit you should also replace the transport stopper to fix the disc tray
securely in place.
1 Press CD SELECT 3.
2 Press OPEN/CLOSE
0 for disc 1.
3 Thread the tip of the stopper through the hole on the front left of
the disc tray, from the top.
4 Bring the tip round and through the hole on the front of the
stopper. Pull to make sure there is no slack.
5 Bend the tip down flush with the stopper and fix it in place with
tape.
6 Press STANDBY/ON.
The disc tray should closed. Don’t press any other buttons.
7 Unplug the unit.
Magnetic shielding of speakers
The speaker system is not magnetically shielded. This means that if the speakers are
placed very near a television set or monitor, you may see colour distortion in the picture.
Move the speaker(s) further away from the television to solve the problem.
If you wish to connect speakers other than the ones supplied, use only speakers with a
nominal impedance of between 6
Ω
and 16
Ω
. Refer to your speaker’s operating
instructions if you’re unsure of their impedance before connecting them and switching on.
1