Pioneer X-MT2000 - Manuel (Page 11)

11
2 Connecting Up
English
En
Connecting to other components
The CD receiver has analog audio inputs and outputs for connecting up other
components. Possible uses for the analog inputs include sound from a VCR or satellite
receiver, an MD or tape deck, or turntable (with suitable phono amplifier). Use a standard
stereo audio cable (with RCA/phono plugs on either end) to connect the
AUX IN
(auxiliary inputs) on this unit to the audio out sockets on the other component. Be sure
to match the color-coded plugs and sockets at both ends for best results.
If you want to record from this unit to an external MD, CD-R or tape recorder, connect the
AUX OUT (auxiliary outputs) of this unit to the audio inputs of your recorder. (If you're
connecting to a digital recorder, be careful to use the analog inputs.) Again, use a
standard stereo audio cable, matching the colours on the plugs and sockets both ends for
best results.
SUB—WOOFER
OUT
S
Plugging in to an AC outlet
After making sure that everything is properly connected, plug in to a power outlet. After
plugging in, a demonstration sequence starts in the display. Press
STANDBY / ON (front
panel) or POWER (remote) to stop the demo, or see the back page for how to turn it
off completely.
Power cord caution
Handle the power cord by the plug part. Do not pull out the plug by tugging the cord, and
never touch the power cord when your hands are wet, as this could cause a short circuit or
electric shock. Do not place the unit, a piece of furniture, or other object on the power
cord or pinch the cord in any other way. Never make a knot in the cord or tie it with other
cords. The power cords should be routed so that they are not likely to be stepped on. A
damaged power cord can cause a fire or give you an electric shock. Check the power cord
once in a while. If you find it damaged, ask your nearest Pioneer authorized service center
or your dealer for a replacement.
AUX OUT
AUX IN
R L
L R
L R
Tape deck, MD
recorder, etc.
Turntable, MD
player, etc.
Using a sub-woofer
If you want more powerful bass than the provided speakers deliver, connect a powered
sub-woofer to the
SUB - WOOFER OUT jack. See the instructions that come with the
sub-woofer for detailed installation instructions.
• Connect the sub-woofer to this system using a standard audio cord with RCA/phono
plugs.
• It is possible to use a passive sub-woofer. Connect the SUB - WOOFER OUT of this
system to a suitable amplifier, then connect the sub-woofer to that amplifier.
• The SUB - WOOFER OUT signal is a mono mix of the left and right channels.