Pioneer X-MT2000 - Manuel (Page 26)

26
6 Using the Tuner
En
TUNER
FM/AM
ENTER
SNOOZE TIMER
POWER
4 ¢
VOLUME
VOLUME
+
—
REMOTE CONTROL UNIT
AUX
FUNCTION VOLUME
DISPLAY/
CLOCK
TIMER
ENTER (DEMO)
TIMER
STANDBY
STANDBY/ON
BASS/TREBLE
CD SELECT OPEN/CLOSE
TUNING
! ⁄
› $
)
)
)
&
#*
1
2
3
Waking up to the radio or auxiliary
component
You can use the timer as an alarm clock to wake up to the radio or component connected
to the auxiliary inputs, such as a satellite tuner. Once the timer is active, it will operate
everyday at the set time.
Note: If there is a power failure or the system is unplugged from the wall outlet, the
display shows AM 12:00 once power is restored until you reset the clock. You can’t use the
timer until you set the clock.
Activating/deactivating the timer
The timer has to be active before it will have any effect.
1 Press and hold TIMER for about a second.
If the timer is currently inactive, then
TMR ON ? appears in the display, prompting you
to activate the timer. If the timer is currently active, TMR OFF ? appears, prompting you
to deactivate it.
2 Press ENTER to set.
• You can check whether the timer is currently active at any time by pressing
TIMER .
The display shows TMR ON or TMR OFF .
Setting the wake up time
Unlike an ordinary alarm clock, you need to set a system switch off time as well as a
switch on time.
1 Switch to tuner and tune to the station you want to wake up to.
If you’re using an auxiliary component, switch to
AUX , then set up the component for
playback.
2 Set the volume.
Remember, things sound louder first thing in the morning!
3 Press and hold TIMER until the display shows TIMER? (about 3
seconds), then press ENTER.
4 Set the switch on time.
Use
4 and ¢ to set the hour then press
ENTER . Set the minute in the same way,
pressing ENTER to finish.
5 Set the switch off time.
Set in the same way as the switch on time.
6 Check the settings you just made.
The display should indicate that you set the wake up timer, then show the on time, the off
time, the function (
TUNER or AUX ), and the volume.
There isn't any way to edit these settings, so if you need to change something, simply set
the timer again.