Pioneer VSX-917V - Manuel (Page 69)

Additional information 12
69
En
English
Français
Deutsch
Nederlands
Italiano
Español
SIRIUS radio messages
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the  STANDBY/ON button
for about three seconds.
3 When you see RESET? appear in the
display, press ENTER.
OK? shows in the display.
4 Press SETUP to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory settings.
Switching the speaker
impedance
We recommend using speakers of 8 Ω with
this system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6
Ω impedance rating.
• With the receiver in standby, press 
STANDBY/ON while holding down the
SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6
Ω.
• SP 8 OHM – Use this setting if your
speakers are rated at 8
Ω or more.
Symptom Cause Action
Antenna Error Antenna is not properly connected. Check that the antenna cable is
attached securely.
Check Sirius Tuner SIRIUS Connect tuner is not properly connected Check that the 8 pin mini DIN cable
and AC Adapter are attached securely.
Acquiring Signal The SIRIUS signal is too weak at the current
location. n/a
Subscription Updating Unit is updating subscription. Wait until the encryption code has
been updated.
Updating Channels Unit is updating channels. Wait until the encryption code has
been updated.
Invalid Channel Selected channel is not available/does not exist. Select another channel.
VSX_917.book.fm Page 69 Thursday, December 7, 2006 4:40 PM