Pioneer VSX-917V - Manuel (Page 33)

Listening to your system 05
33
En
English
Français
Deutsch
Nederlands
Italiano
Español
Using the Sound Retriever
When audio data is removed during the
compression process, sound quality often
suffers from an uneven sound image. The
Sound Retriever feature employs new DSP
technology that helps bring CD quality sound
back to compressed 2-channel audio by
restoring sound pressure and smoothing
jagged artifacts left over after compression. 1
• Press SOUND RETRIEVER to switch the
sound retriever on or off.
Enhancing dialog
• Default setting: OFF
The Dialog Enhancement feature localizes
dialog in the center channel to make it stand
out from other background sounds in a TV or
movie soundtrack.
• Press DIALOG (DIALOGUE
ENHANCEMENT) to switch dialog
enhancement on or off.
Using the tone controls
Depending on what you are listening to, you
may want to adjust the bass or treble using the
front panel tone control.
2
1 Press TONE to select the frequency you
want to adjust.
Press to switch between
BASS and TREBLE.
2 Use the MULTI JOG dial to change the
amount of bass or treble as necessary.
Wait about five seconds for your changes to be
input automatically.
Playing other sources
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to playback.
Use the input select buttons. 3
4 Start playback of the component you
selected in step 1.
Choosing the input signal
• Default setting: AUTO
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
4
• Press SIGNAL SEL (SIGNAL SELECT) to
select the input signal corresponding to the
source component.
Each press cycles through the options as
follows:
• AUTO – This is the default setting. The
receiver selects the first available signal in
the following order:
DIGITAL; ANALOG.
• ANALOG – Selects an analog signal.
Note
1 The Sound Retriever is only applicable to 2-channel sources.
2 The tone controls are only available when Stereo or Front Stage Surround Advance mode are selected (except when
STEREO
is selected using AUTO SURROUND).
3 If your source is the TV’s built-in tuner, switch to the channel you want to watch, otherwise make sure that the TV’s video input
is set to this receiver (For example, if you connected this receiver to the
VIDEO jacks on your TV, make sure that the VIDEO input
is selected). Turn down the volume of your TV so that all the sound is coming from the speakers connected to this receiver.
4 • This receiver can only play back Dolby Digital, PCM (32 kHz to 96 kHz), DTS and WMA9 Pro digital signal formats. With other
digital signal formats, set to
ANALOG.
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (Connecting other audio components on page 15) and set the signal input to DIGITAL.
• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
VSX_917.book.fm Page 33 Thursday, December 7, 2006 4:40 PM