Pioneer VSX-917V - Manuel (Page 48)

Controlling the rest of your system 09
48
En
Selecting preset codes directly
1 While pressing the RECEIVER button,
press and hold the SETUP button.
The remote LCD display shows
SETUP.
2 Use / to select PRESET then press
ENTER.
3 Press the MULTI CONTROL button for the
component you want to control then press
ENTER.
The LCD on the remote displays the
component you want to control.
1
4 Use / to select the first letter of the
brand name of your component then press
ENTER.
This should be the manufacturer’s name (for
example,
P for Pioneer).
5 Use / to select the manufacturer’s
name from the list then press ENTER.
6 Use
/ to select the proper code from
the list, then try using this remote control
with your component.
The code should start with the component type
(for example,
DVD 009). If there is more than
one, start with the first one.
To try out the remote control, switch the
component on or off (into standby) by pressing
SOURCE
. If it doesn’t seem to work, select
the next code from the list (if there is one).
7 If your component is controlled
successfully, press ENTER to confirm.
The remote LCD display shows
OK.
Erasing one of the remote
control button settings
This erases a control assigned to one of the
buttons and restores it to the factory default.
1 While pressing the RECEIVER button,
press and hold the SETUP button.
The remote LCD display shows
SETUP.
2 Use / to select ERASE then press
ENTER.
3 Press the MULTI CONTROL button
corresponding to the button setting to be
erased then press ENTER.
The LCD on the remote displays the
component.
4 Press and hold the button to be erased for
two seconds.
The LCD display shows
OK or NO CODE to
confirm the button has been erased.
5 Repeat step 4 to erase other buttons.
6 Press the RECEIVER button when you’re
done.
Erasing all of the remote control
presets
This will erase all preset remote control preset
codes.
1 While pressing the RECEIVER button,
press and hold the SETUP button.
The remote LCD display shows
SETUP.
2 Use / to select RESET then press
ENTER.
Note
1 You can’t assign the RECEIVER button.
ANALOG
ATT SB ch SLEEP
RECEIVER SOURCE INPUT
SELECT
TV DVR TV CTRL
CD RECEIVER AM FM
DVD
XM RADIO SIRIUS CD-R/TAPE
F.AUDIO
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
MIDNIGHT DIMMER SR+
+10 D.ACCESS
SIGNAL SEL
CLASS DISC
TV CONTROL
VOL
TUNE
TUNE
INPUT
SELECT TV CH TV VOL
ENTER
TOP MENU
CATEGORY
T.EDIT DTV MENU
MENU
RETURN
GUIDE
SETUP ENTER
ST ST
VSX_917.book.fm Page 48 Thursday, December 7, 2006 4:40 PM