Sharp PG-M15X - Manuel (Page 27)

Operation
25
Remote Control/Wireless Mouse Positioning
• The remote control and the wireless mouse functions can be used to control the projector within the ranges
shown below.
• The remote control can be used with the wireless mouse functions to control the mouse operation on the computer
connected to the projector.
• The signal from the remote control can be reflected off a screen for easy operation. However, the effective distance of the
signal may differ due to the screen material.
Operating the Wireless Mouse from the Remote Control
Controlling the Projector or Using the Wireless Mouse Functions
Remote control
Using as a Wireless Mouse
• When MOUSE is pressed, the buttons on the remote
control light up and the remote control enters MOUSE
mode.
• During MOUSE mode, the cursor can be used as the
pointer. MOUSE mode is for about ten seconds while
the buttons are lighting.
• When MENU or ENLARGE is pressed, MOUSE mode
is released to the normal mode.
• The wireless mouse may not operate correctly if your
computer is not correctly set up. Refer to the computer’s
operation manual for details of setting up/installing the
mouse driver.
• For one-button mouse systems, use either LEFT-CLICK or
RIGHT-CLICK.
• To conserve battery life, MOUSE stays active for
approximately 10 seconds. Reactivate by pressing MOUSE
again.
Effective buttons in MOUSE mode
Remote control
(Front view)
Remote control
(Rear view)
Mouse
RIGHT-CLICK
LEFT-CLICK
23
Ј (7 m)
23
Ј (7 m)
30˚
30˚
30˚
45˚
45˚
Remote control
Remote control sensor
MOUSE CONTROL
OPERATION