Sharp PG-M15X - Manuel (Page 24)

Operation
22
Setting up the Screen
Using the Adjustment Feet
You can adjust the height of the image by raising the projector with the
foot release.
1 Lift the projector and press HEIGHT ADJUST.
(The adjuster comes out.)
2 While pressing HEIGHT ADJUST, lower the projector to adjust
the height. (Adjustable up to approximately 8° from the standard
position)
3 Remove your finger from HEIGHT ADJUST at the desired angle.
4 Rotate the rear adjuster to adjust the projector exactly.
(Adjustable up to approximately 1° from the left rear foot)
Returning the projector to its original position
While holding the projector, press HEIGHT ADJUST and slowly lower the
projector to its original position.
• When an adjustment is made, the image may become distorted (keystoned), depending
on the relative positions of the projector and the screen.
• Optimal image quality can be achieved when the projector is positioned perpendicular to the screen with all feet flat and level.
Reversed Image Setup
Projection using a mirror
• When the distance between the projector and screen
is not sufficient for normal rear projection, you can
use a mirror to reflect the image onto the screen.
• Place a mirror (normal flat type) in front of the lens.
• Project the normal image onto the mirror.
• The image reflected from the mirror is projected onto
the translucent screen.
Rear projection
• Place a translucent screen between the projector and
the audience.
• Use the projector’s menu system to reverse the
projected image. (See page 44 for use of this
function.)
CAUTION
• When using a mirror, be sure to carefully position both the projector and the mirror so the light does not shine into the eyes of
the audience.
Ceiling-mount Setup
• It is recommended that you use the optional Sharp ceiling-mount
bracket for this installation.
• Before mounting the projector, contact your nearest Sharp
Authorized Projector Dealer or Service Center to obtain the
recommended ceiling-mount bracket (sold separately). (AN-
PGCM85 ceiling-mount bracket and its AN-EP101A extension tube
(for U.S.A.), or AN-M15T ceiling-mount bracket and its AN-TK201/
AN-TK202 extension tubes (for countries other than the U.S.A.))
• When the projector is in the inverted position, use the upper edge
of the screen as the base line.
• Use the projector’s menu system to select the appropriate projection
mode. (See page 44 for use of this function.)
CAUTION
• Do not press HEIGHT ADJUST when the adjustment foot is extended without firmly holding the projector.
• Do not hold the lens when lifting or lowering the projector.
• When lowering the projector, be careful not to get your fingers caught between the table and the projector.