Sharp PG-M15X - Manuel (Page 21)

Operation
19
5 8
7
6
Basic Operations
3 Rotate the ZOOM knob. The image can be
adjusted to the desired size within the zoom range.
4 Rotate the FOCUS ring until the image on the
screen becomes clear.
5 Press INPUT to select the desired input mode.
Press INPUT again to change the mode.
Projector
• When the selected input signal is being received, “Adjusting
The Image” will be displayed.
• When no signal is being received, “NO SIGNAL” will be
displayed. When a signal that the projector is not preset to
receive is being received, “NOT REG.” will be displayed.
• You can display all input modes one by one when “Auto
Source” is set to “OFF”.
5
EXAMPLE
6
7
8
Remote control
Zooming/Focusing
INPUT 1
(DVI) Mode
INPUT 1
(RGB) Mode
INPUT 2
(S-VIDEO) Mode
INPUT 1
(COMPONENT) Mode
f
f
f
INPUT 3
(VIDEO) Mode
f
6 Press VOLUME on the remote control to adjust
the volume.
7 Press AV MUTE on the remote control to
temporarily turn off the picture and the sound.
Press AV MUTE again to turn the picture and the
sound back on.
8 Press ON/OFF on the projector or POWER on the
remote control, and then press ON/OFF or
POWER again while the message is displayed to
turn off the power.
• If you accidentally pressed ON/OFF or POWER and do not
want to turn off the power, wait until the power off screen
disappears.
• When ON/OFF or POWER is pressed twice, the POWER
indicator illuminates red and the cooling fan will run for about
90 seconds. The projector will then enter standby mode.
• Wait until the cooling fan stops before disconnecting the
power cord.
• The power can be turned on again by pressing ON/OFF or
POWER. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicator light green.
VOLUME 5 1