John Deere AC-2600GH - Manuel (Page 23)

AC-Series Operator’s Manual-E/F 23
PIC81-102299R0
PIC85-102299R0
CHANGING NOZZLE
CAUTION: High pressure spray can cause serious
injury. Keep away from spray. Never point the gun
at yourself or anyone else. Never put your hand,
fingers, eyes or body directly over spray. Do not
point spray toward fragile materials.
CAUTION: To avoid injury from escaping fluids
under pressure, relieve the pressure in the system
by stopping the washer and depressing gun
trigger. Lock trigger before changing or adjusting
nozzle.
Be sure nozzle is tightly attached before operating
to help prevent nozzle release.
1. Retract locking ring (A) of quick-connect fitting and
remove nozzle (B).
2. Insert nozzle and push ring forward and lock nozzle in
place. Be sure nozzle is fastened to wand.
SELECTING THE PROPER NOZZLE
Pressure and volume are partially determined by the size
of the orifice in the nozzle. Standard numbers are on the
nozzles to indicate spray pattern and orifice size. For
example, a nozzle stamped 25055 has a 25° spray pattern
and a 5.5 orifice.
0° NOZZLE-RED
This nozzle is a blasting nozzle, delivering a concentrated
stream of water.
IMPORTANT: Care must be used to avoid gouging wood
or damaging fragile surfaces.
Recommended uses are as follows:
-Removing stains from concrete, masonry, aluminum
and steel.
-Remove weeds from sidewalk cracks.
-Remove caked-on mud from equipment.
-Clean lawn mower underdeck.
B
A
Operating the Washer