John Deere AC-2600GH - Manuel (Page 21)

AC-Series Operator’s Manual-E/F 21
Operating the Washer
STARTING AND OPERATING ENGINE
CAUTION: Do not run engine in an enclosed area.
Exhaust gas contains carbon monoxide, an odorless
and poisonous gas that can cause sickness or
death.
IMPORTANT: To prevent possible pump damage, do not
allow washer pump to run in bypass (with gun
trigger released) for longer than 3 minutes.
IMPORTANT: During first two hours of engine operation,
engine may operate at low or erratic RPM as
the engine moving parts break in.
NOTE: AC-2000GH, AC-2400GH & AC-2400GS illustrated.
1. Set fuel valve lever (A) right to ON position. (Not applicable
on AC-2000GH / AC-2600GH.)
2. Move choke control lever (B) left to “CHOKE” position.
(AC-2000GH / AC-2600GH: Pull choke control lever (B)
out.)
NOTE: A warm engine requires less choking than a cold
engine.
3. Move throttle lever (C) to the left. (AC-2000GH / AC-
2600GH: Move throttle lever (C) upward.)
4. Turn engine switch (D) to “ON” position. (Not applicable
on AC-2000GH / AC-2600GH)
5. Place foot on washer frame.
6. Point nozzle away from people, animals or fragile materials
and squeeze gun trigger.
CAUTION: Be sure nozzle output end is not directed
at bystander or objects. Pressurized output spray
will start almost instantaneously at engine start-up
and can cause serious personal injury or property
damage. Release trigger immediately upon engine
start.
7. Pull recoil starter grip lightly until resistance is felt, then pull
briskly until engine starts.
IMPORTANT: Do not allow starter grip to snap back against
engine. Return it gently to prevent damage
to starter.
IMPORTANT: To avoid loss of lubrication to the engine,
operate engine on a level surface. Do not
exceed a 15° slope or automatic low oil
switch will stop engine. (Not applicable on
AC-2000GH / AC-2600GH)
8. As engine starts to falter, move choke control lever (B) right
to OPEN position.
9. Position throttle lever (C) to desired speed.
STOPPING THE ENGINE
AC-2000GH / AC-2600GH ONLY:
IMPORTANT: To stop engine in emergency, turn throttle (C)
down to ‘OFF” position.
1. Move throttle lever (C) to “OFF”.
2. Trigger gun to relieve spray.
ALL OTHER MODELS:
IMPORTANT: To stop engine in emergency, turn engine
switch (D) to ‘OFF” position.
NOTE: AC-2400GH and AC-2400GS illustrated.
1. Move throttle lever (C) fully to the right.
2. Turn engine switch (D) to “OFF” position.
3. Move fuel valve (A) left to “OFF” position.
4. Trigger gun to relieve spray.
PIC66R•121902R0
C
D
A
B
PIC158•1
13099R0
C
B
AC-2000GH
AC-2400GH
DWG14-102299R0
PIC66•102299R0
AC-2400GS
D
C
A
B