Juniper Networks ISG 2000 - Manuel (Page 36)

Chapter 3 Configuring the Device
30 User’s Guide
3. Launch a Command Line Interface (CLI) session between your computer and
the NetScreen-ISG 2000 using a standard serial terminal emulation program
such as Hilgraeve Hyperterminal (provided with your Windows operating
system). The settings should be as follows:
• Baud Rate to 9600
• Parity to No
• Data Bits to 8
• Stop Bit to 1
• Flow Control to none
4. Press the enter key to see the login prompt.
5. At the login prompt, type netscreen.
6. At the password prompt, type netscreen.
7. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To change this timeout interval:
set console timeout number
where number is the length of idle time in minutes before session termination.
To prevent any automatic termination, specify a value of 0.
Changing Your Admin Name and Password
Because all NetScreen products use the same admin name and password (netscreen), it
is highly advisable to change your admin name and password immediately. To change
your login information:
set admin name name_str
set admin password pswd_str
save
For information on creating different levels of administrators, see the NetScreen Concepts
and Examples ScreenOS Reference Guide.
Note: Both login and password are case-sensitive.