Rear-and-front mount – Juniper Networks ISG 2000 Manuel d'utilisation
Page 23
Equipment Rack Mounting
NetScreen-ISG 2000
17
Rear-and-Front Mount
To mount the NetScreen-ISG 2000 with support from the rear and front, use the rear slide
mount kit.
1.
Screw the left and right plates to the front of each side of the
NetScreen-ISG 2000 chassis.
2.
Screw the rear mount bracket to the rear rack posts.
3.
With the indented groove that runs the length of each slide facing outward,
screw the slides to the middle of each side of the NetScreen-ISG 2000 chassis.
4.
Slip the slides into the rear mount brackets.
5.
Push the NetScreen-ISG 2000 forward until the left and right plates contact the
front rack posts.
6.
Screw the left and right plates to the rack.
Note:
Depending on the depth of your equipment rack, you can attach the slides
along the length of the sides or extend them over the rear of the chassis.