Juniper Networks ISG 2000 - Manuel (Page 14)

Chapter 1 Overview
8 User’s Guide
Compact Flash
The compact flash slot is for downloading or uploading system software or configuration
files, and for saving log files to a compact flash card.
To download or upload, execute the CLI command save:
save
{ software | config }
from { flash | slot1 filename } to
{ flash | slot1 filename }
where flash refers to internal flash memory, slot1 refers to the compact flash slot, and
filename is the name of the software or configuration file on the card.
For example, the following command downloads the current device configuration to a file
named ns2000_config on a card in the compact flash slot:
save config from flash to slot1 ns2000_config
Management Interfaces
The NetScreen-ISG 2000 offers three management interfaces:
Port Description
Console This RJ-45 serial port is for local configuration and administration using the CLI.
Connect the console port to your workstation using an RJ-45 female to DB-9 male
straight-through serial cable.
Modem This RJ-45 serial port is for connecting to a modem, allowing the user to control the
device remotely. (For security reasons, it is advisable to use a modem only for
troubleshooting or for a one-time configuration, not for regular remote administration.)
10/100 MGT This management port has a fixed 10/100 Base-T interface and provides a dedicated,
out-of-band connection for management traffic. It has a separate IP address and
netmask, configurable with the CLI or WebUI. (For security reasons, do not pass
session traffic through this interface.) The MGT port is not capable of routing traffic to
other interfaces. This port is only to be used for management purposes. The default IP
address for the MGT port is 192.168.1.1.