6. engine prestart checks – Miller Electric Big Blue 400 PX Manuel d'utilisation

Page 29

Advertising
background image

OM-229 979 Page 23

5-6. Engine Prestart Checks

.

Check all engine fluids daily.

Engine must be cold and on a level surface.

Unit is shipped with 20W break-in oil.
Automatic shutdown system stops engine if

oil pressure is too low or coolant tempera-

ture is too high.

.

This unit has a low oil pressure shut-

down switch. However, some condi-

tions may cause engine damage before

the engine shuts down. Check oil level

often and do not use the oil pressure

shutdown system to monitor oil level.

Follow run-in procedure in engine manual.

If unburned fuel and oil collect in exhaust

pipe during run-in, see Section 10.
Fuel
NOTICE
− Do not use gasoline. Gasoline

will damage engine.
The unit is shipped with enough fuel to pre-

vent air from entering fuel system. Add fresh

diesel fuel before starting (see engine main-

tenance label for fuel specifications). Leave

filler neck empty to allow room for

expansion.

Do not run out of fuel or air will enter fuel sys-

tem and cause starting problems. See en-

gine manual to bleed air from fuel system.

Oil

After fueling, check oil with unit on level sur-

face. If oil is not up to full mark on dipstick,

add oil (see maintenance label).

Coolant

Check coolant level in radiator before start-

ing unit the first time. If necessary, add cool-

ant to radiator until coolant level is at bottom

of filler neck.

Check coolant level in recovery tank daily.

If necessary, add coolant to recovery tank

until coolant level is between Cold Full and

Hot Full levels. If recovery tank coolant level

was low, also check coolant level in radiator.

Add coolant if level is below bottom of radia-

tor filler neck.

Unit is shipped with an engine coolant mix-

ture of water and ethylene glycol base anti-
freeze rated to −34

°

F (−37

°

C). Add anti-

freeze to mixture if using the unit in tempera-
tures below −34

°

F (−37

°

C).

Keep radiator and air intake clean and free

of dirt.

NOTICE − Incorrect engine temperature

can damage engine. Do not run engine with-

out a properly working thermostat and ra-

diator cap.

.

To improve cold weather starting:

Use Preheat switch (see Section 6-2).

Keep battery in good condition. Store

battery in warm area.

Use fuel formulated for cold weather

(diesel fuel can gel in cold weather).

Contact local fuel supplier for fuel in-

formation.

Use correct grade oil for cold weather

(see Section 8-1).

Full

Capacity:

6 qt (5.7 L)

Diesel

Full

Hot Full

Cold Full

Check radiator coolant

level when fluid is low in

recovery tank.

Coolant Recovery Tank

Ref. 804 009−C

Full

Advertising