Curtis RWD200 - Manuel (Page 7)

P.07
Tools and Parts
Gather the required tools and parts before starting installation. The parts supplied are in
the washer drum.
INSTALLATION REQUIREMENTS
Transport Hole Plug
1/4 nut driver 3/8 socket with ratchet
3/8″ open end wrench
Adjustable wrench or 7/16″ socket with ratchet
Adjustable wrench or 9/16″ open- end wrench
Channel- lock adjustable pliers
Carpenter’s level ″ ″
-
Water Hoses(2)
Cable Tie
Warning!
Failure to comply with these warnings could result in serious
personal injuries.
Note : Environmental Protection
- If you plan to dispose this machine, please comply with the local waste disposal
regulations. Cut off the power cord so that it will not be put into reuse.
Remove the door so that kids and animals will not be trapped in the machine.
- Do not use excessive detergents.
- Decontaminant and bleacher can be used to pre-treat the stains on the clothes only
when very necessary.
WARNING – Risk of Fire
Clothes dryer installation must be performed by a qualified installer.
Install the clothes dryer according to the manufacturer’s instructions and local codes.
These conditions will obstruct clothes dryer airflow and increase the risk of fire.
To reduce the risk of severe injury or death, follow all installation instructions.
Save these instructions.
1.This machine must be earthed properly. If there is any short circuit, earthing can reduce
the danger of electrical shock.
This machine is equipped with power cord, which includes plug, earthing wire at earthing
terminal.
2.Washing machine shall be operated in a circuit separate from other electrical appliances.
Otherwise, power protector may be tripped or fuse may be burned out.
！ WARNING