Curtis BTC511 - Manuel (Page 10)

10
Should you wish to use the system with a CO2 cartridge:
- Locate the flexible air or CO2 inlet tube.
N.B.: The flexible air or CO2 inlet tube is equipped with a ‘backstop valve’. The red arrow
on the valve, indicating the direction of connection, must be directed towards the WHITE
adaptor. In the event of poor connection, the beverage will leak into the pump, resulting
in the machine having to be returned to our technical department for examination and
repair at your expense.
- Place the flexible tube over the metal ‘CO2’ nozzle and fasten the retaining spring over
the top of it to ensure the connection is perfectly airtight.
- Connect the flexible tube to the ‘AIR IN’ nozzle of the WHITE adaptor. The red arrow on
the flexible tube must be positioned to face the WHITE adaptor.
- Move the pump slide to AIR OFF (slide to the bottom). The pump does not need to be
sending out air as the pressure will be provided by the cartridge.
For information on attaching the CO2 cartridge see the paragraph on ‘Positioning and
connecting the CO2 cartridge’.
10. Check that the tubes are not bent before closing the lid of the machine. If this is the
case, gently rotate the keg to undo any kinks in the tubes. The beverage outlet tube must
form a continuation of the handle so as not to interfere with the closing of the lid. To
ensure that this is the case, place the tube in the white plastic collar located at the top
of the vat. The collar will now hold the outlet tube onto the shaft of the tap, thus
preventing it from being crushed when the lid is closed.
11. Rinse and wipe up any traces of spillage thoroughly.
12. Close the lid of the machine.
13. Plug the connector into the machine's power socket and press the switch to the rear
of the appliance.
14. Adjust the temperature.
The temperature display on the front of the machine will indicate the temperature
inside the machine on the outer wall of the keg.
The cooling temperature can be adjusted by turning the temperature regulation
button clockwise to reduce (-) or anti-clockwise to increase (+) the temperature.
You will then need to allow some time for the content of the keg to reach the temperature
indicated on the display, which is why it is recommended that you perform this operation
before serving the first beverage from the keg.
FITTING A 6L PRESSURISED BEER KEG
The WHITE adaptor for 6L kegs and plastic kegs is compatible with
6L pressurised kegs.
1 Locate the WHITE adaptor. Check that the connection valves on the tubes are
disconnected from each end of the adaptor. If this is not the case, remove them by
pressing the metal tab.