Vintage Cellars 6SDZE - Manuel (Page 26)

TROUBLESHOOTING YOUR WINE CELLAR
Problem Possible Cause Remedy
Unit not cold enough.
Adjust temperatures (See
“Changing Current Settings”
on page 6).
• Control set too warm.
• Content temperature not stabilized.
• Excessive usage or prolonged door openings.
• Airflow to front grille blocked.
• Door gasket not sealing properly.
• Adjust temperature colder. Allow 24 hours
for temperature to stabilize.
• Allow temperature to stabilize for at least 24
hours, with minimal door openings.
• Airflow must not be obstructed to front
grille. See “clearances” on page 4.
• Check door alignment and/or adjust or
replace door gasket.
Unit too cold.
Adjust temperatures (See
“Changing Current Settings”
on page 6).
• Control set too cold.
• Door gasket not sealing properly.
• Adjust temperature warmer. (See page 6,
“set the desired temperature”). Allow 24
hours for temperature to stabilize.
• Check door alignment and/or adjust or
replace door gasket.
No interior light inside
cabinet.
• Bulb burned out. • See “Care and Cleaning” page 25 or contact
a qualified Aga Marvel service representa-
tive.
Light will not go out when
door is closed.
• Door not activating light switch.
• Display light function has been activated.
(Glass door models only).
• Verify cabinet is level, refer to page 4 for
leveling instructions.
• Verify the door is aligned properly, refer to
page 19 for instructions.
• Turn off display lighting.
Noise or Vibration. • Unit not level • Level unit, see “Leveling Legs” on page 4.
Unit will not run. • Unit turned off
• Power cord not plugged in.
• No power at outlet.
• Turn unit on. See “Start your Appliance” on
page 6.
• Plug in power cord.
• Check house circuit.
Before You Call for Service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the troubleshooting
guide below. Locate the problem in the guide and refer to the
cause and its remedy before calling for service. The problem may
be something very simple that can be solved without a service
call. However, it may be required to contact a qualified service
technician.
Electrocution Hazard - Never at
tempt to repair or perform main-
tenance on the unit until the main electrical power has been
disconnected. Turning the unit control “OFF” does not remove
electrical power from the units wiring.
If Service is Required:
• If the product is within the first year warranty period please
contact your dealer or call AGA MARVEL Customer Service
at 800.223.3900 for directions on how to obtain warranty
coverage in your area.
• If the product is outside the first year warranty period, AGA
MARVEL Customer Service can provide recommendations of
service centers in your area. A listing of authorized service
centers is also available at www.agamarvel.com under the
service and support section.
• In all correspondence regarding service, be sure to give the
service number, serial number, located on your products se-
rial plate, and proof of purchase.
• Try to have information or description of nature of the prob-
lem, how long the unit has been running, the room temper-
For Your Records
Date of Purchase
Dealer’s name
Dealer’s Address
Dealer’s City
Dealer’s State
Dealer’s Zip Code
Appliance Serial Number
Appliance Service Number
Date Warranty Card Sent (Must be
within 10 days of purchase).
26
Table D
ature, and any additional information that may be helpful in
quickly solving the problem.
• Table D is provided to document pertinent information
regarding your product for future reference.