Vintage Cellars 6SDZE - Manuel (Page 19)

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS
Figure 8
Door should be
parallel to top
and sides of
refrigerator.
Step 2: Remove door
Remove the top hinge pin from the hinge with an 1/8” allen
wrench. Remove the door by angling the top of the door out-
ward and lifting the door off the bottom hinge.
(See detail in Figure 8).
Step 3: Remove gasket
Lay the door on its front being careful not to scratch it. Remove
the door gasket by peeling up and out of the channel.
Step 4: Cut overlay panel
Depending on the wine cellar model cut the overlay panel to the
dimensions shown. Use Figure 9 and Table A for solid door mod-
els or use Figure 10 and Table B for glass door models.
H
W
Front of
overlay
panel
Figure 9
NOTE
NOTE
For overlay with lock option panel thickness to be
3/4” (19mm) maximum to 5/8” (16mm) minimum.
Weight of the overlay panel should not exceed 20 pounds (9.1
kilograms).
For the door to close properly it is necessary to maintain a
minimum space of 9/32” (7mm) between the door and cabinet
flange (see Figure 8). This space can be adjusted by adjusting the
top and bottom hinge adapter brackets.
Hinge adapter bracket lo-
cated on the top and bottom
of the door.
Remove top
hinge pin to re-
move the door.
9/32”
(7mm)
Model W H
3SWCE
14-5/8”
(37.13cm)
30-5/16”
(76.99cm)
6SWCE
23-5/8”
(59.99cm)
30-5/16”
(76.99cm)
Table A
Solid Door Models
Solid Door Models
19
Step 1: Verify door alignment
Verify that the door is aligned correctly with the cabinet prior
to fabricating the custom panel. Failure to do so could result in
mis-alignment of the custom panel with the hinge bracket. The
door should be parallel to the sides and top of the refrigerator.
If alignment is necessary the door may be adjusted by loosen-
ing the 2 screws which secure the upper and/or lower hinge
adapter brackets, located on the top and bottom of the door,
and adjusting the door side to side. Use a 5/32” allen wrench for
this procedure. (See Figure 8 below). When finished aligning the
door, tighten the screws securely.
W
Front of
overlay
panel
Figure 10
1-23/32”
(38.77cm)
Typical 4
Sides
Glass Door Models
H