Sony STR-DE705 - Manuel (Page 7)

Getting Started
Rear and center speakers
Rear speaker Rear speaker
(R) Receiver Center speaker (L)
Where do I go next?
To complete your system, go to "AC Hookups" on page 8. If
you want to connect video components to enjoy surround
sound when watching TV programs or video tapes, go on to
the next section.
Active woofer
Receiver Active woofer
If you have an additional front speaker system
Connect them to the FRONT SPEAKERS B terminals.
'Q' If your TV monitor uses separate speakers
You can connect one of them to the SURROUND
SPEAKER CENTER terminals for use with Dolby Pro
Logic Surround Sound (see page 18).
Selecting the impedance (STR-DE705 and
STR-D650Z only)
Set the IMPEDANCE SELECTOR for the front speakers
as indicated in the table below. Check the instruction
manual of your speakers if you're not sure of the
impedance. (This information is usually printed on a
label on the back of the speaker.)
if nominal impedance of Set IMPEDANCE SELEaOR to'
your speaker is
Between 4 and 8 ohms 4Q -
8 ohms or higher sn
TV/VCR Hookups
Overview
This section describes how to connect video
components to the receiver. For specific locations of the
jacks, see the illustration below.
MONITOR TV VIDEO 2
VIDEO 1
What cables will I need?
• Audio / video cable (not supplied) (1 for each TV or LD
player; 2 for each VCR)
Yellow
White (L)=0
Red (R)
Yellow
<BZN= White (L)
Red (R)
• Video cable (not supplied) (1 for a TV monitor)
Yellow Yellow
Selecting the speaker system
If you connect ortly one set of front speakers, set the
SPEAKERS selector on the front panel to A. If you
connect two sets of front speakers, see the following:
To drive Set SPEAKERS selector to
Speaker system A (connected
to the FRONT SPEAKERS A
terminals) A
Speaker system B (connected
to the FRONT SPEAKERS B
terminals) B
Both speaker systems A and
B (parallel connection) A+B*
"■Do not use A+B with SOU?^ FIELD set to ON.
Hookups
The arrow indicates signal flow.
TV or Digital Broadcasting System (DBS) tuner
Receiver TV
(continued)