Hookups, Tape deck, Oat/md – Sony STR-DE705 Manuel d'utilisation

Page 6: Turntable, If your turntable has an earth lead, Speaker system hookups, Overview, What cords will i need, Front speakers, X t j

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

Getting Started

Hookups

The arrow indicates signal flow,

CD player

Receiver

CD player

Tape deck

Receiver

Tape deck

OAT/MD

Receiver

DAT/MD

Turntable

Receiver

Turntable

If your turntable has an earth lead

To prevent hum, connect the earth lead to the rh ground
terminal on the receiver.

CONTROL A1 Hookups (USA and Canadian
STR-DE705 only)

• If you have a CONTROL A1 compatible Sony CD player

or tape deck

Use a COi^TROL A1 cord (not supplied) to connect the
S-LINK CTRL A1 jack on the CD player or tape deck to the
S-LINK CTRL A1 jack on the receiver. Refer the separate
manual "CONTROL-Al Control System" and the
Operating Instructions supplied with your CD player or
tape deck for details.

• If you have a Sony CD changer with a COMMAND

MODE selector

If the CD changer's COMMAND MODE selector can be
switched between CD I, CD 2, and CD 3, be sure to set the
command mode to "CD 1" and connect the changer to the
CD terminals on the receiver.
However, if you have a Sony CD changer with VIDEO

OUT terminals, set the command mode to "CD 2" and
connect the changer to the VIDEO 2 terminals on the
receiver.

Where do I go next?

Go on to the next section to connect the speakers.

Speaker System Hookups

Overview

This section describes how to connect your speakers to
the receiver. Although front (left and right) speakers
are required, center and rear speakers are optional.
Adding center and rear speakers will enhance the
surround effects. Connecting an active woofer will

increase bass response.
For specific locations of the terminals, see the

illustration below.

IMPEDANCE

SURROUND
SPEAKERS REAR

SURROUND
SPEAKERS CENTER

For optimum surround sound effect, place your
speakers as shown below.

What cords will I need?

Speaker cord (not supplied) (1 for each speaker)

(-)

(*)

(-)

Twist the stripped ends of the cord about 2/3 inch (15 mm).
Be sure to match the speaker cord to the appropriate

terminal on the components: + to + and - to If the cords
are reversed, the sound will be distorted and will lack bass.

Hookups

Front speakers

Front speaker

(R)

Receiver

Front speaker

(L)_

eo

N N
¥ ¥ ¥

X T

J

N M M

iPEPANCe I sE*-

1

«n

eo

f

Advertising