Sony STR-DE705 - Manuel (Page 5)

Getting Started
Antenna Hookups
Overview
This section describes how to connect AM and FM
antennas to the receiver. If you want to receive radio
broadcasts with the receiver, complete these
connections first, then go to the following pages.
For specific locations of the terminals, see the
illustration below.
What antennas will I need?
• FM wire antenna
(supplied) (1)
Hookups
FM wire antenna
After connecting
the wire antenna,
keep it as horizontal
as possible.
AM loop antenna
(supplied) (1)
Receiver AM loop antenna
*Q" If you have poor FM reception
Connect a 75'Ohm coaxial cable (not supplied) to an FM
outdoor antenna.
FM outdoor antenna
Connecting a ground wire
To prevent hum, connect a ground wire (not supplied)
to the th ground terminal. If you've connected an
outdoor antenna, be sure to connect the ground for
lightning protection.
Receiver
----- j
♦
to ground
Where do I go next?
If you want to connect other components, go on to the next
section. If you're only planning to use the receiver to listen
to the radio, go to "Speaker System Hookups" on pages 6
and 7.
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the receiver. If you want to use the
receiver as an amplifier, complete these connections.
For specific locations of the jacks, see the illustration
below.
PHONO CD DAT/MD
What cords will I need?
Audio cords (not supplied) (1 for each CD player and
turntable; 2 for each tape deck, DAT deck, or MD deck)
White (L) =
Red (R) ‘
■ White (L)
Red (R)
(continued)