Napoleon Fireplaces Linear Patioflame - Manuel (Page 13)

www.napoleongrills.com
13
EN
7. Reconnect the stainless steel flex connector to the orifice and tighten using (2) wrenches.
8. Place the glass tray over the burner and fasten to the patio flame with the screws removed in step
2.
9. Fill out the conversion label included with your patio flame and apply it to the inside of the control
panel access door.
10. A leak test must be performed according to the leak testing instructions found in the manual.
Natural Gas Hook-Up
The gas appliance is designed to operate at an inlet pressure of 7 inches water column. The piping up
to the appliance is the responsibility of the installer. A flexible
metal connector is included to simplify the installation of the unit.
Connect the flexible connector to rigid pipe, copper tube or an
approved flexible metal connector, which complies with Z21.4/
CSA 6.10. If using a gas hose (not supplied) connect the flared
end of the hose to the connector on the end of the flex tube
as illustrated. Tighten using two wrenches. (Do not use thread
sealer/pipe dope.) Leak test all joints prior to using the appliance.
Piping and valves upstream of the quick disconnect are not
supplied. The gas supply pipe must be sufficiently sized to supply
the BTU/h specified on the rating plate, based on the length of the piping run. The quick disconnect
must not be installed in an upward direction and a readily accessible manual shut-off valve must be
installed upstream of, and as close to, the quick disconnect as is feasible.
Purge the gas supply line of any trapped air prior to the first firing of the unit.
WARNING!
• The installation must be performed by a licensed gas fitter, and all connections must be leak tested
before operating the appliance.
• Ensure all hose connections are tightened using two wrenches. Do not use Teflon tape or pipe
dope on any hose connection.
• Ensure the hose does not contact any high temperature surfaces or it may melt and leak causing a
fire.
• Locate the hose out of pathways where people may trip over it or in areas where the hose may be
subject to accidental damage.
• Leak test all the connections using a soap and water solution as per the leak testing instructions
found in the manual.