Napoleon Fireplaces XIR3 - Manuel (Page 13)

W415-1033 / B / 07.15.13
13
EN
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of
the small logs. Care should be taken to shred the embers into thin, small irregular pieces as only the exposed
edges of the fibre hairs will glow. The ember material will only glow when exposed to direct flame;
however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect flame pattern, carbon deposits and delayed ignition. PHAZER
TM
logs glow when exposed to direct flame. Use only certified "glowing embers" and PHAZER TM logs available
from your authorized dealer / distributor.
97.1A
Remove the backing of the logo supplied and place on the glass viewing door,
as indicated. ½"
(12.7mm)
LOGO
½"
(12.7mm)
4.4 OPTIONAL ROCK PLACEMENT
4.5 GLOWING EMBERS
4.6 LOGO PLACEMENT
Before beginning with the installation, remove the door and all burner media from the appliance including logs
and charcoal strips. Retain the glowing embers.
D. Reinstall the glowing embers over the burner.
E. Reinstall the door.
!
WARNING
REAL ROCKS MUST NOT BE USED IN THIS APPLIANCE. HEAT WILL CAUSE THEM TO EXPLODE
A. Sit the two rock clusters on top of the rear log support. Ensure the clusters are sitting flat.
B. Place the large notched rocks along the step behind the front burner as desired.
C. Place the remaining rocks around the burner as desired making sure not to cover any burner ports
(there are no set locations).