Napoleon Fireplaces XIR4 - Manuel (Page 13)

W415-1194 / A / 12.19.13
13
EN
4.4 LOG PLACEMENT
!
WARNING
FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
DAMAGE OR PERSONAL INJURY.
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
IGNITION MAY OCCUR.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
76.1A
PHAZER TM logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that is
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours
may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
PINS
4. Place the centre charcoal
piece* into position, lining up the
hole in the bottom with the stud in
the front centre of the log support. 6. Place the rear log against the
back panel, lining up the holes
with the studs at the back of the
fi rebox. Locate 3 pins (supplied)
into the top of the log. 5. Place the right front charcoal
piece* into position, lining up the
holes in the bottom with the studs
in the front right corner.
1. Place the right charcoal piece
into position, lining up the holes
in the bottom with the studs in the
right side of the burner. 3. Place the left front charcoal
piece* into position, lining up the
holes in the bottom with the studs
in the left front corner. 2. Place the left charcoal piece
into position, lining up the bottom
holes with the studs to the left side
of the burner.
* These front pieces have a lip to distinguish them from the other charcoal pieces.