Napoleon Fireplaces NPI45 - Manuel (Page 39)

W415-0702 / B / 04.04.12
39
To clean the burn pot, open the door and knock away any debris on the
burn pot. If severely clogged, remove the burn pot to gain better access.
If removing the burn pot set aside on a non-combustible surface. Once
removed, discard all material that has accumulated in the burn pot.
Make certain that all openings are clear of any build up of ash from the
ledge below the burn pot.
Re-install the burn pot ensuring it sits level in the
appliance. Also must ensure the ignitor and the burn
pot locating notch line up when reinstalling the burn
pot.
40.6A
IGNITOR
LOCATING
NOTCH
MAKE CERTAIN THE HEATER HAS FULLY COOLED (APPROXIMATELY 25 MINUTES) BEFORE
OPENING THE DOOR AND
!
WARNING
The more frequently you clean out the fl y ash, the more effi cient your appliance
will burn.
A. Open the viewing door.
B. Lift the burn pot out and set aside on a non-combustible surface.
C. Vacuum out the fi rebox. Do not use a household
vacuum to clean the appliance. We recommend that
you use a shop vacuum that is equipped with a fi ne
dust fi lter or a vacuum specifi cally made for ashes and soot.
Using a vacuum which is not equipped with a fi ne dust fi lter may
clog and disperse fl y ash and soot into the room. NOTE: The
appliance must be completely out before you vacuum the
appliance. Live pellets, if sucked into the vacuum will light
the vacuum on fi re and may ultimately cause a house fi re.
Re-install the burn pot ensuring it sits level in the appliance. Also must ensure the ignitor and the burn pot
locating notch line up when reinstalling the burn pot.
40.18
FIREBOX
AIR
HOUSING
THE FIREBOX BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE COOL COM-
PLETELY BEFORE CONDUCTING SERVICE.
NEVER VACUUM HOT EMBERS.
!
WARNING
10.1.8 CLEANING THE BURN POT
10.2 BI-WEEKLY (OR EVERY 10 BAGS OF PELLETS)
10.2.1 VACUUM
FIREBOX