Napoleon Fireplaces NPI45 - Manuel (Page 2)

W415-0702 / B / 04.04.12
2
NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.
TABLE OF CONTENTS
1.0 INSTALLATION OVERVIEW 3
1.1 STOVE 3
1.2 INSERT 4
2.0 INTRODUCTION 5
2.1 DIMENSIONS 6
2.1.1 STOVE 6
2.1.2 NPI45 COMPLETE WITH NI800 FLASHING 6
2.1.3 NPI45 COMPLETE WITH AK8 ADAPTER AND GICSK FLASHING 7
2.1.4 NPI45 COMPLETE WITH AK9 ADAPTER AND CISK FLASHING 8
2.2 SPECIFICATIONS 9
2.2.1 HEATING SPECIFICATIONS 9
2.3 GENERAL INSTRUCTIONS 9
2.4 GENERAL INFORMATION 10
2.4.1 PELLET SPECIFICATIONS 10
2.4.2 SAFETY FEATURES 11
2.4.3 EPA COMPLIANCE 11
2.5 RATING PLATE INFORMATION 12
3.0 INSTALLATION PLANNING 13
3.1 APPLIANCE PLACEMENT 13
3.2 INSTALLATION OPTIONS 13
3.3 STOVE MINIMUM CLEARANCE TO COMBUSTIBLES 14
3.3.1 STRAIGHT INSTALLATION 14
3.3.2 CORNER INSTALLATION 14
3.3.3 ALCOVE INSTALLATION REQUIREMENTS (MINIMUM) 15
3.4 FLOOR PROTECTION REQUIREMENTS INSTALLATION 16
3.5 OUTSIDE AIR 17
3.6 MOBILE HOME 17
4.0 VENTING 18
4.1 TYPE OF VENT 18
4.2 INSTALLING THE PELLET VENT 18
4.3 VENTING THE PELLET APPLIANCE 18
4.4 PELLET VENT TERMINATION 19
4.5 VENT TERMINAL CLEARANCES 19
4.5.1 HORIZONTAL EXHAUST THROUGH WALL INSTALLATION 20
4.5.2 THROUGH THE WALL WITH VERTICAL RISE / HORIZONTAL TERMINATION 20
4.5.3 MINIMUM INSIDE VERTICAL CLEARANCES 21
4.5.4 CLASS A CHIMNEY RETROFIT 21
4.5.5 HEARTH MOUNT INSTALLATION 22
4.6 INSERT VENTING INSTALLATION EXAMPLES 23
4.6.1 TYPICAL EXISTING MASONRY INSTALLATION 23
4.6.2 FACTORY BUILT FIREPLACE 24
5.0 FRAMING (INSERT ONLY) 25
5.1 INSTALLATION INTO A COMBUSTIBLE ENCLOSURE 26
5.2 MINIMUM ENCLOSURE CLEARANCES 27
5.3 MINIMUM CLEARANCE TO COMBUSTIBLES 27
5.4 MINIMUM MANTEL CLEARANCES 28
5.5 REAR TO TOP VENT CONVERSION INSTRUCTIONS 29
6.0 FINISHING 29
6.1 INSTALLING VIEWING DOOR 29
6.2 FLASHING INSTALLATION 30
6.3 TRIVET INSTALLATION 30
7.0 WIRING DIAGRAM 31
8.0 OPERATING INSTRUCTIONS 32
8.1 PROPER PELLET LOADING 32
8.2 START UP CYCLE 32
8.3 LIGHTING APPLIANCE MANUALLY 32
8.4 LIGHTING INSTRUCTIONS 33
8.5 CONTROLS 33
8.6 CONTROL ADJUSTMENT 34
8.7 INSTALLING A THERMOSTAT OR REMOTE CONTROL 35
8.8 SHUTDOWN INSTRUCTIONS 35
9.0 NORMAL OPERATING SOUNDS 36
10.0 MAINTENANCE 37
10.1 DAILY (WHENEVER USING THE APPLIANCE) 37
10.1.1 OPENING MAIN DOOR 37
10.1.2 DISPOSAL OF ASHES 37
10.1.3 INSPECT THE BURN POT 37
10.1.4 CARE OF PLATED PARTS 37
10.1.5 CARE OF GLASS 38
10.1.6 CLEANING THE HEAT EXCHANGER TUBES 38
10.1.7 MAKE SURE PELLETS ARE NOT PILING UP 38
10.1.8 CLEANING THE BURN POT 39
10.2 BI-WEEKLY (OR EVERY 10 BAGS OF PELLETS) 39