Napoleon Fireplaces Swarovski - LHD50SS - Manuel (Page 52)

52
W415-0839 / D / 08.15.12
A. Remove the valve train assembly and set aside, see “VALVE
TRAIN ASSEMBLY” section. Disconnect the wires to the control
module, labeling one end to aid with their re-connection.
B. Remove the 4 screws holding the control module shield in place.
C. Remove the 2 screws holding the control module in place, unplug
and remove.
D. Replace and reinstall components.
NOTE: Control module ON/OFF switch should always be in the “ON” position. If for any reason the
module is turned “OFF”, the components plugged into the module won’t have power.
11.4 BURNER REMOVAL
11.5 CONTROL MODULE REMOVAL
A. Remove the valve train assembly and set aside, see “VALVE TRAIN ASSEMBLY” section. Disconnect
the wires to the control IPI Board and/or the AC Adaptor, see CONTROL ACCESS” section for
components locations.
Label one end of each wire to aid with their re-connection.
Components are held in place with velcro. Pull off and replace components as required.
11.6 IPI BOARD AND AC ADAPTOR ACCESS
SCREWS
A. Remove the bevelled trim, glass door,
porcelain wrap and porcelain side panels, see
“FINISHING” section.
B. Remove the media tray by using the fi nger
holes and lifting the tray up and out.
HELPFUL HINT: Prior to removing the
media tray, carefully remove crystals and
clean before reinstalling, see “MEDIA
INSTALLATION” section.
C. Remove the 8 screws that secure the burner in
place. Lift the burner up and out.
MEDIA TRAY
BURNER
FINGER
HOLES
CONTROL
MODULE SHIELD