Napoleon Fireplaces Vector 45 - LHD45 - Manuel (Page 42)

W415-0834 / E / 06.13.13
42
EN
8.3 WIRING DIAGRAM
69.5A
!
WARNING
DO NOT WIRE 110 VOLTS TO THE VALVE OR WALL SWITCH.
ON / OFF
SWITCH
ACS/IPI
SWITCH
(OPTIONAL)
BATTERY
HOUSING
GROUND
DFC
VALVE
ORANGE
GREEN
GROUND
EYELET
ON / OFF
IPI / CPI
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH. CONNECT
AN OPTIONAL THERMOSTAT
OR REMOTE CONTROL AND
IF ALLOWED WITH THIS
APPLIANCE A “B” VENT
ADAPTOR.
IPI BOARD
DC SUPPLY
TRANSFORMER
VALVE
ELECTRONIC
WITH “B” VENT ADAPTORS THE SPILL SWITCH MUST BE WIRED IN SERIES WITH EITHER THE
EXISTING SWITCH OR OPTIONAL WALL SWITCH, THERMOSTAT OR REMOTE.
OFF ON
This appliance comes equipped with a battery back-up. If this backup is used, install 4 AA batteries (not
supplied) into the holder and connect to the wire harness. Place near the IPI board. Connect the battery
holder to the wire harness before using the appliance. Place near the IPI board. If backup is used, it must be
connected to the 6 volt battery pack (supplied).