Napoleon Fireplaces High Definition 81 - HD81 - Manuel (Page 35)

W415-0687 / G / 08.26.13
35
EN
If access to the control area is necessary AFTER INSTALLATION, remove the access panel or electrical box
cover located inside the fi rebox. The access panel must be re-installed before operating the appliance.
It is necessary to hard wire this appliance.
Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired.
7.0 ELECTRICAL INFORMATION
7.1 HARD WIRING CONNECTION
7.2 OPTIONAL BLOWER INSTALLATION
Wire Harness Assembly
IPI Board
Pilot
Ground
Wire
EI
Pilot
Spark Electrode
Flame
Sensor
Valve
Electronic Modulation
120V OUT FAN AUX OUT
COM
POWER
ACS/IPI Switch
Receiver
Wire Harness
Control Module
Night Lights Fan
Wire
Harness
Plug
!
WARNING
DO NOT USE THIS APPLIANCE IF ANY PART HAS BEEN UNDER WATER. CALL A QUALIFIED
SERVICE TECHNICIAN IMMEDIATELY TO HAVE THE APPLIANCE INSPECTED FOR DAMAGE TO THE
ELECTRICAL CIRCUIT.
RISK OF ELECTRICAL SHOCK OR EXPLOSION. DO NOT WIRE 110V TO THE VALVE OR TO THE
APPLIANCE WALL SWITCH. INCORRECT WIRING WILL DAMAGE CONTROLS.
ALL WIRING SHOULD BE DONE BY A QUALIFIED ELECTRICIAN AND SHALL BE IN COMPLIANCE
WITH LOCAL CODES. IN THE ABSENCE OF LOCAL CODES, USE THE CURRENT CSA22.1 CANADIAN
ELECTRIC CODE IN CANADA OR THE CURRENT NATIONAL ELECTRIC CODE ANSI/NFPA NO. 70 IN
THE UNITED STATES.
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RAN OUT,
WITH THE GLASS DOOR OPENED OR REMOVED.
69.2
7.3 SCHEMATIC
See separate instructions accompanying the blower assembly.