Napoleon Fireplaces Madison - GD80 - Manuel (Page 47)

47
W415-0695 / D / 08.13.12
W385-0368
(4) AA Batteries
The valve on your appliance is piped with two fl ex connectors (one inlet, one
outlet). It can be removed or pulled forward for service.
A. Remove the hearth strip.
B. Open the right control door.
C. Remove the switch plate by pulling on the left side.
D. Remove the valve housing by pulling on the handle.
E. Lift up and set the housing towards the back of the appliance.
F. Remove the wing nut and pivot the valve out from the slot at the
bottom of the valve.
G. Slowly pull the valve through the control door careful not to kink the gas lines or wires.
H. Replace all components before returning the appliance to service.
HANDLE
RECEIVER
PLATE
HOUSING
VALVE
SLOT
SPARK MODULE
VALVE
WING NUT
A. Open the right control door by pulling bottom portion away from magnet
catch.
B. Remove the hearth strip by lifting up and away from unit.
C. Remove the receiver by pulling the left side of the plate away from the
bracket.
D. Once disengaged pull the wiring harness out from the back of receiver.
CONSTANTLY POWERED 120V OUTLET
FAN OUTLET
120V AUX OUTLET
MAINS VOLTAGE
SUPPLY CORD
MODULE ON/OFF SWITCH
COMMUNICATION BUS (3 PIN
HANDLE
RECEIVER
PLATE
HOUSING
VALVE
11.4 REMOTE RECEIVER REMOVAL
11.5 VALVE REMOVAL