Napoleon Fireplaces Torch - GT8 - Manuel (Page 30)

30
W415-0794 / D / 05.30.11
8.0 OPERATION
Ensure that a continuous gas fl ow is at the burner before installing the door. When lit for the fi rst time, the
fi replace will emit an odor for a few hours. This is a normal temporary condition caused by the “burn-in” of
paints and lubricants used in the manufacturing process and will not occur again. After extended periods of
non-operation such as following a vacation or a warm weather season, the fi replace may emit a slight odor for
a few hours. This is caused by dust particles in the heat exchanger burning off. In both cases, open a window
to suffi ciently ventilate the room.
FOR YOUR SAFETY READ BEFORE LIGHTING:
A. This fi replace is equipped with an ignition device which automatically lights the pilot. Do not try to light
by hand.
B. Before operating smell all around the fi replace area for gas and next to the fl oor because some gas is
heavier than air and will settle on the fl oor.
C. Do not use this fi replace if any part has been under water. Immediately call a qualifi ed service techni-
cian to inspect the fi replace and replace any part of the control system and any gas control which has
been under water.
WHAT TO DO IF YOU SMELL GAS:
• Turn off all gas to the fi replace.
• Open windows.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use
any phone in your building. • Immediately call your gas supplier from
a neighbour’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier,
call the fi re department.
LIGHTING INSTRUCTIONS:
1. Stop! Read the above safety information on this label.
2. Turn off all electrical power to the fi replace.
3. This fi replace is equipped with an ignition device which auto-
matically lights the pilot. Do not try to light the pilot by hand.
4. Open the glass door.
5. Wait fi ve (5) minutes to clear out any gas. If you smell gas
including near the fl oor, STOP! Follow “B” in the above safety
information on this label. If you don’t smell gas go to the next
step.
6. Close the glass door.
7. Turn on all electric power to the fi replace and re-install
batteries into the transmitter.
8. Turn the fi replace switch to the ON position.
9. If fi replace will not operate, follow instructions “To Turn Off Gas” and call your service technician or gas supplier.
1. Turn the fi replace switch to the OFF position.
2. Turn off all electrical power to the fi replace if service is to be performed.
3. Turn manual shut-off valve clockwise to off. Do not force.
TO TURN OFF GAS:
47.8
O S
MANUAL SHUT-OFF
(SHOWN IN OFF POSITION)
A
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
!
WARNING