Sony DCR-IP7BT - Manuel (Page 18)

18-
GB
(7) Enter the passkey.
For details on how to input characters, see “How to input characters” on page
8.
For example, when using the BTA-NW1 Modem Adaptor with Bluetooth
Function, the passkey is its serial number which is indicated on the label on the
rear panel.
Tip on “Passkey”
The passkey is an identification number needed to allow two Bluetooth devices
to communicate with each other. The connection will be permitted after
entering the passkey. This “Passkey” is also referred to as a “Bluetooth
passkey”, “PIN”, “Bluetooth PIN”, etc. For details, refer to the operating
instructions supplied with the Bluetooth adaptor.
(8) Select [Enter], then press the centre z on the control button.
After the registration is completed, the Bluetooth Setup screen appears again.
The selected Bluetooth device is specified.
, ,
Note
When the message “Bluetooth Registration Error Check the Passkey” is
indicated, select [OK], then press the centre z on the control button. Carry out
the procedure again from step 4.
(9) Select [Exit], then press the centre z on the control button.
The Setup screen appears again. For details on how to turn off the Modem
Adaptor with Bluetooth Function, refer to the operating instructions supplied
with the Modem Adaptor with Bluetooth Function.
(10) Select [Exit], then press the centre z on the control button.
The Network Menu appears again.
MODEM ADAPTOR WITH BLUETOOTH TM FUNCTION
MODEL NO. BTA-NW1 ®
Passkey
The number used when registering a
Bluetooth device
Registering a Bluetooth device