Sony DCR-IP7BT - Manuel (Page 15)

15-
GB
Preparation
This section describes making a registration of a Bluetooth device. Here we describe the
procedure for registering the Sony Modem Adaptor with Bluetooth Function. Once the
registration is completed, the camcorder can connect to the Bluetooth device without
reregistering the device. Up to three Bluetooth devices can be registered. Also, refer to
the operating instructions supplied with the Bluetooth device.
For more information about Bluetooth devices compatible with the camcorder, access
the following URL:
•http://www.sony.ca/service
•http://www.sony-europe.com/imaging, then click “support”
•http://www.sony-asia.com.sg/helpdesk
Only for the DCR-IP7BT/PC120BT
The Sony BTA-NW1 Modem Adaptor with Bluetooth Function is supplied with the
DCR-IP7BT/PC120BT. This unit has already been registered to your DCR-IP7BT/
PC120BT.
Notes
•When using the Sony BTA-NW1 Modem Adaptor with Bluetooth Function, install it
in a location that has no obstacles between the camcorder and the device. The distance
between the devices must be within 10 m (33 feet).
•The connection may be interrupted depending on the conditions in which the
communication is taking place.
When using the Modem Adaptor with Bluetooth Function
1 Preparing the Modem Adaptor with Bluetooth Function
Set the Modem Adaptor with Bluetooth Function to connection standby (BONDING).
For details, refer to the operating instructions supplied with the Modem Adaptor with
Bluetooth Function.
– Preparation –
Registering a Bluetooth device