Sony STR-DA3300ES - Manuel (Page 72)

72 GB
You can select the test tone type.
5
Select the speaker you want to
adjust, then press
.
The test tone is output from each speaker
in sequence.
6
Adjust the parameter using V/v,
then press .
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–.
• The adjusted value is shown on the display
during adjustment.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely. Check to see if they are connected
securely and cannot be disconnected by
pulling on them slightly.
• The speaker cords may have the short-circuit
problem.
When a test tone is output from
a different speaker than the
speaker displayed on the
screen
The speaker pattern to the connected speaker
is not set up correctly. Make sure the speaker
connection and the speaker pattern match.
x Test Tone
• OFF
• AUTO
The test tone is output from each speaker in
sequence.
• FIX
You can select which speakers will output
the test tone.
x Phase Noise
• OFF
• L/R, L/C, C/R, R/SL, R/SR, SR/SL, SR/
SBR, SBR/SBL, SR/SB, SBL/SL, SB/SL,
SL/L, L/SR
Lets you output the test tone sequentially
from adjacent speakers.
Some items may not be displayed,
depending on the setting of the speaker
pattern.
x Phase Audio
• OFF
• L/R, L/C, C/R, R/SL, R/SR, SR/SL, SR/
SBR, SBR/SBL, SR/SB, SBL/SL, SB/SL,
SL/L, L/SR
Lets you output front 2 channel source sound
(instead of the test tone) sequentially from
adjacent speakers.
Some items may not be displayed,
depending on the setting of the speaker
pattern.
x Sur Back Assign
(Settings of the surround back
speaker(s))
• OFF
If you have not connected surround back
speakers, select “OFF.”
• BI-AMP
If you connect front speakers in a bi-
amplifier configuration, select “BI-AMP”.
Test Tone menu parameters
Other menu parameters of
Speaker settings