Sony STR-DA3300ES - Manuel (Page 46)

46 GB
Note
You cannot measure the speaker height of the
surround speakers and the surround back speakers.
Set the position of the surround speakers from
“Position” in the Speaker settings menu.
Tips
• Operations other than turning the receiver on or off
are deactivated during the measurement.
• In the following situations, the measurements have
not been performed correctly or auto calibration
cannot be performed.
– when connecting special speakers, such as
dipole speakers.
– when using the zone 2 function in zone 2.
To cancel the measurement
The measurement is cancelled when you
change the volume, switch functions, change
the setting of the SPEAKERS switch, or
connect headphones.
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the TV screen.
Note
When the speaker(s) is (are) out of the phase,
“Out Phase” is displayed on the TV screen.
The “+” and “–” terminals of the speaker may
be connected the other way around. However,
depending on the speakers, “Out Phase”
appears on the TV screen even though the
speakers are connected properly. This is
because of the speakers’ specifications. In this
case, you can continue to use the receiver.
Tip
The displayed unit of distance for models for
US and Canada is feet. The unit of distance for
models for countries/areas other than US and
Canada is meters. You can change the unit of
distance use in “Distance Unit” in the Speaker
settings menu.
2
Press to select “Next.”
When “Save auto calibration (auto
speaker setup) results?” appears on the
TV screen, you can select whether to
confirm the warning (“Yes”) or not
(“No”).
Follow the instructions of the TV screen
when you select “Yes.”
For details on warning and error codes,
see “Message list after auto calibration
measurement” (page 48).
Tip
Press on the remote when “Please Press
ENTER.” appears on the TV screen.
3
Press B/b repeatedly to select
“Yes,” then press .
4
Press V/v repeatedly to select
the auto calibration type, then
press
b.
The measurement results are saved.
Confirming/saving the
measurement results