GE ZDIS150ZSS - Manuel (Page 2)

Installation Instructions
‡
BEFORE YOU BEGIN:
Read these instructions completely and carefully.
‡
IMPORTANT:
Save these instructions for local inspector’s use.
‡
IMPORTANT:
Observe all governing codes and ordinances.
‡ Note to Installer – Be sure to leave these
instructions with the Consumer.
‡ Note to Consumer – Keep these instructions with
your Owner’s Manual for future reference.
WARNING:
This appliance must be properly grounded.
Failure to do so can result in death, fire or electrical
shock. See “Power Supply,” page 6.
AVERTISSEMENT :
Cet appareil doit être correctement mis à la terre.
Le non-respect de ces instructions peut causer la
mort, un incendie ou un choc électrique. Consulter «
Alimentation électrique », page 6.
If you received a damaged ice maker, you should
immediately contact your dealer or builder.
Proper installation is the responsibility of the
installer. Product failure due to improper installation
is not covered under the GE Appliance Warranty.
See the Owner’s Manual for warranty information.
‡8VHWKLVDSSOLDQFHRQO\IRULWVLQWHQGHGSXUSRVH
Check with local utilities for electrical codes that
apply in your area. Local codes vary. Installation,
electrical connections and grounding must comply
with applicable codes. In the absence of local codes,
the ice maker should be installed in accordance
with National Electrical Code ANSI/NFPA 70-1990 or
latest edition.
For Monogram local service in your area, call
1.800.444.1845.
For Monogram Service in Canada, call
1.800.561.3344.
For Monogram Parts and Accessories, call
1.800.626.2002.
2
CONTENTS
Design Information
Models Available .................................................................... 3
Optional Accessories ........................................................... 3
Tools and Materials Required ........................................ 3
Cutout & Product Dimensions ......................................... 4
Installation
Advance Planning ................................................................. 4
Water Supply ........................................................................... 5
Power Supply ........................................................................... 6
Remove Packaging ............................................................... 6
Water Filtration System ................................................. 6, 7
Adjust Height of Ice maker ............................................... 7
Connect the Drain ................................................................. 9
Connect Water Supply to Appliance ............................ 9
Reverse Door Swing ...................................................10, 11
Accessories
ZPK2 Auxiliary Pump Kit ............................................ 12-15
ZIP75BB Kit for 3/4” thick panels ..........................16, 17