GE ZDIS150ZSS - Manuel (Page 11)

Installation Instructions
11
STEP 3 - REVERSE HINGES
 8QVFUHZKLQJHVFUHZVDQGUHPRYHWKHWRSKLQJH
Replace screws in empty hinge holes.
2. Remove screws from opposite side of ice maker
cabinet. Turn top hinge upside down so the hinge
pin points up. Place hinge on the bottom opposite
side of ice maker and tighten screws.
3. Remove original bottom hinge screws and hinge.
Replace screws in the empty hinge holes.
4. Remove screws from top of opposite side of ice
maker cabinet. Turn hinge upside down so the
hinge pin points down. Place hinge on top opposite
side of ice maker cabinet and tighten screws.
5. Remove the top hinge pin.
REVERSE THE DOOR SWING (cont.) REVERSE THE DOOR SWING (cont.)
Hinge
Hinge Pin
Hinge Screw
Top Hinge
STEP 4 - REPLACE DOOR
For Black Model:
Align handle with the holes in the door and replace
screws. Tighten.
For Stainless Steel Model:
1. Replace the door skin on the door. Start by placing
the top of the skin over the top of the door. Slide
the sides in behind the side protectors. Line up
the bottom of the skin with the two holes on the
bottom of the door.
2. Replace two hex screws in the bottom of the
stainless steel door skin.
STEP 5 - REVERSE DOOR CATCH
1. Remove the plastic screws from the op po site side
of the door.
2. Remove the metal screws from the mag net ic door
catch and reinstall on the op po site side of the door.
3. Install the plastic screw into place on the op po site
side of the door.
Hinge
Hinge Screws
Hinge Pin
Bottom Hinge
Door Catch