GE ZDIS150ZSS - Manuel (Page 13)

13
1. 8QSOXJSRZHUFRUGIURPUHDUFRYHU
2. Remove screws holding the rear cover. Retain
screws. Carefully pull rear cover away from drain
tube.
3. Remove old drain tube and clamp attached to bin.
Discard the tube and clamp.
Installation Instructions
STEP 1 - REMOVE ORIGINAL PARTS
Old Drain Hose
Clamp
Old Drain Tube
Remove Screws
NOTE: If pump is being installed on a ice maker that
has not been completely installed, please proceed
to Drain Pump Install section.
1. Attach vent tube to pump with new 5/8” hose
clamp. Attach drain tube from bin to pump with
7/8” hose clamp.
2. Coil ice machine power cord into a 4” dia. coil and
secure with electrical tape. Place the coil onto the
top of the pump.
1. Position pump at the right side, just outside of the opening.
2. Plug the ice machine power cord into the front of
the pump.
STEP 2 - CONNECT ELECTRICAL
Pump Power Cord
Ice
machine
Power
Cord
STEP 3 -INSTALL NEW TUBING
Plug Ice machine
Power Cord into
Pump
New 7/8”
Adjustable
Hose
Clamp
Vent Tube
5/8”Adjustable
Hose Clamp