Onkyo AV RECEIVER HT-R990 - Manuel (Page 57)

57
En
Main menu Remote Controller Setup
Remote Mode Setup
See “Looking up for Remote Control Code”
(
➔
page 64).
With this preference, you can protect your settings by
locking the setup menus.
Main menu Lock Setup
■ Setup
`
Locked
`
Unlocked
When “Locked” is selected, the setup menus will be
locked and you cannot change any setting.
You can change various audio settings from the Home
menu (
➔
page 39).
Note
• These settings are not available in either of the following cases:
– a pair of headphones is connected.
– the “Audio TV Out” setting is set to “On” (
➔
page 55).
– “HDMI Control(RIHD)” is set to “On” ( ➔ page 54) and
you’re listening through your TV speakers.
Tone Control Settings
■
Bass
`
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut low-frequency sounds output
from the front speakers.
■
Treble
`
–10dB to 0dB to +10dB in 2 dB steps.
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when the Direct or THX listening mode is selected.
Operating on the AV receiver
Speaker Levels
■
Subwoofer Level
`
–15dB to 0dB to +12dB in 1 dB steps.
■
Center Level
` –12dB to 0dB to +12dB in 1 dB steps.
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
here, go to “Level Calibration” (
➔ page 45) before
setting the AV receiver to standby.
Note
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” in “Speaker Configuration”
(
➔
page 44) cannot be adjusted.
Audyssey
■ Audyssey
See “Audyssey” in “Source Setup” (
➔
page 48).
■
Dynamic EQ
See “Dynamic EQ” in “Source Setup” (
➔
page 48).
■
Dynamic Volume
See “Dynamic Volume” in “Source Setup” (
➔
page 49).
Note
• These technologies can be used when all the following
conditions are met:
– Room Correction and Speaker Setup is completed. Note that
“Audyssey” requires the “Audyssey 2EQ Full Calibration”
method.
– Any listening mode other than Direct is selected.
– A pair of headphones is not connected.
• The setting is stored individually for each input selector.
Remote Controller Setup
Lock Setup
Using the Audio Settings
1 Press RECEIVER followed by HOME.
2 Use / and ENTER to select “Audio”, and then
use / / / to make the desired selection.
1 Press TONE repeatedly to select either “Bass” or
“Treble”.
2 Use + and – to adjust.