Onkyo AV RECEIVER HT-R990 - Manuel (Page 45)

45
En
Level Calibration
Here you can adjust the level of each speaker with the
built-in test tone so that the volume of each speaker is the
same at the listening position.
■
Left, Front High Left, Center *1 , Front High Right,
Right, Surround Right, Surround Back Right,
Surround Back Left, Surround Left
`
–12dB to 0dB to +12dB in 1 dB steps.
■
Subwoofer *1
`
–15dB to 0dB to +12dB in 1 dB steps.
Note
• These settings cannot be calibrated in either of the following
cases:
– a pair of headphones is connected.
– the “Audio TV Out” setting is set to “On” (
➔ page 55).
– “HDMI Control(RIHD)” is set to “On” (
➔
page 54) and
you’re listening through your TV speakers.
– the AV receiver is muted.
• Speakers that you set to “No” in the “Speaker Configuration”
cannot be selected (
➔
page 44).
• The test tone is output at the standard level for THX, which is
0 dB (absolute volume setting 82). If you normally listen at
volume settings below this, be careful because the test tone will
be much louder.
*1 For the center speaker and subwoofer, the level settings made
by using the Home menu are saved in this menu
(
➔ page 39).
Tip
• If you’re using a handheld sound level meter, adjust the level of
each speaker so that it reads 75 dB SPL at the listening position,
measured with C-weighting and slow reading.
Equalizer Settings
With the Equalizer settings, you can adjust the tone of
speakers individually with a 5-band equalizer. The volume
of each speaker can be set.
■
Equalizer
`
Manual:
You can adjust the equalizer for each speaker
manually. Continue with the following procedure:
` Off :
Tone off, response flat.
Note
• You can select: “63Hz”, “250Hz”, “1000Hz”, “4000Hz”, or
“16000Hz”. And for the subwoofer, “25Hz”, “40Hz”, “63Hz”,
“100Hz”, or “160Hz”.
• When the Direct listening mode is selected, the equalizer
settings have no effect.
• If “Audyssey” is enabled, it prevails over this setting
(
➔
page 48).
This setting is set automatically by Audyssey 2EQ
Room Correction and Speaker Setup (
➔
page 30).
Adjust the level control of the subwoofer to the THX
POSITION before calibrating this system.
1 Press to select “Channel”, and then use
/ to select a speaker.
2 Use / to select a frequency, and then use
the / to adjust the level at that frequency.
The volume at each frequency can be adjusted
from –6dB to 0dB to +6dB in 1 dB steps.
Tip
• Low frequencies (e.g., 63Hz) affect bass sounds;
high frequencies (e.g., 16000Hz) affect treble
sounds.
3
Use to select “Channel”, and then use /
to select another speaker.
Repeat steps 1 and 2 for each speaker.
You cannot select speakers that you set to “No”
in the “Speaker Configuration” (
➔
page 44).